Recent content by a bartholomew

  1. J

    1486 knock/tick

    Hello all, I have a 1486 that has a mild knock or a major tick, I have tracked it down to the MCV area, the linkages that are connected to the MCV twitch with each knock. Any ideas? Thanks
  2. glennster

    wheel horse decals

    any body have a good source for a decal set for a wheel horse raider 8 lawn tractor? gonna paint one for a friend and he would like to get new decals for it. thanks,
  3. C

    My little Oliver

    After three or four years of setting in the back corner of the shop I am getting close to finishing this project. It started as an old Cub Cadet and now it's bright new looking Oliver 1650
  4. A

    282 precup removal

    i have a282 that i have the head off what is the best way to remove the precups
  5. A

    tc35d maintmance times

    how long should it take to service this tractor oil,oil filter,air filter,fuel filter,trans filter and fluid,hydrostat filter just looking for an estimate of time
  6. A

    6400and 2750 maintmance times

    how long should it take to change oil, oil filter, trans filter and fluid,fuel filter ,air filter,and grease all fittings on each of these tractors just looking for a estimate on time
  7. A

    560 origins

    does anybody know where to get information on a 560 and a m wanted to know how to find out what plant they were made in and i was wondering if there is any way to tell what date they were assembeled by the serial# any site or links would be helpful
  8. A

    paint thickness

    i am trying to touch up some bolt after i put some wheels on a 520 deere i am using a small brush i am using jd paint and enamal hardner from napa paint seems thin to brush i can only put a little on or i get a run and body know how i could get this paint thicker i thought about adding the...
  9. A

    520 fuel gague problem

    i need some help on how to test a fuel gegue and sender i have current to the one side of the gague the other side i have nothing but it shows empty when i turn the switch on the gague moves about a needle width all the way to E i need to knw how the system works should i have current on...
  10. A

    520 is it positive or negitive ground

    i am working on a 1957 520 got the generator rebuilt can't get it tocharge i think that the batteries are hooked up positive ground i would like to know if its positive or negative ground
  11. A

    520 decal placement

    520 john deere decal placement i have a set of jorde's decals i thought they came with placement insructions anybody know where i can find this information '
  12. A

    Red Antifreeze

    the orange that gm uses called dex cool mixes with nothing else i think it has a different base . red is probably and extened life i have been told that you could mixgreen with them never tried it
  13. A

    re sand blaster tool tip

    found a sand blaster at northern tool that works great it goes on your pressure washer they have 2 sizes i have the smaller one works better than the small pot blasters in my opnion allyou need is a face sheild
  14. A

    520 trans fluid

    i have drained the rear end grease and the first reduction their are a couple more plugs close to the back i think one that has a real long shank is the power trol drain i need to kwow how to check and fill trans and reduction cover how much to put in ruduction cover howdo you check pto and if...
  15. A

    float ride seat

    have a 520 with a float ride seat. i would like toknow if their are any short cut and where to start, tried to put the rubber bushings and the adjustment screw together first seems to be a lot of tension on every thing not sure if i am starting in the right spot
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top