Recent content by Bohinny

  1. T

    GCTC Pull at Webbers Falls

    Green Country will pull tractors at Webbers Falls, Okla. Sat the 7th at 11AM. Hosting will be Greg Shamblin and Kelley Starbuck with his Crazy Man Sled. Classes from 2600 thru 7000lbs Div II, III, and Open...This is gona be fun..we do have a slight chance of rain, so call Jim, before making the...
  2. B

    Put Put 6v frontmount

    Sounds like the problem I was having on my 49 8n. there was a miss I could not get rid of. After replacing everything electrical and cleaning carb that was new from previous owner. I measuered the jets and the main jet was to small. I drilled it out to 1/16" and put back together set main needle...
  3. B

    bigguy6100

    I just wanted to let you know i fixed my problem with my carb running better with the main needle all the way out. I took the main jet out and the econo jet out to compare size. the econo jet was well over .070" and main was under .040" I guess lack of quality control on replacement carb. i used...
  4. B

    Carb

    do these carbs have different jets for different altitudes. what is the best way to measure the main jet? is there a drill bit size that i could use to check the size. I had my father in law take it apart tonight to recheck pasage ways for me with wire, he said there was one that was...
  5. B

    Carb

    I posted yesterday about the tractor running better with main jet out of carb and 1/4" choke. I checked the carb agin and all pasages are clean and the carb is a m/s241B looks to be fairly new but not certin since i have only owned for several months. I did replace the ignition switch and that...
  6. B

    Carb

    On my 49 front mount 12V, the tractor seams to run better with the choke pulled out about a 1/4 inch. I have installed a new set of points and adjusted them to .015 new plugs al437s gapped .025, drained and flushed the gas tank and all 3 screens pulled the carb apart which I think is the zenith...
  7. B

    1949 8N Starting

    I have the same problem with my 49 runs fine till i shut it off. weather its for 15min or all day it just does not like to start when hot. i am trying a few thing to fix, but dont know the cuase.
  8. B

    49 front mount dizy

    it is 12v and the point are less then year old premium set from this web site. from the decription on setting the points i was probably forcing the the guage more then i should have. any ideas on the hard to start when hot. the tractor is at the farm 2 hours away so it will be sometime before i...
  9. B

    49 front mount dizy

    What are the symptoms of having point gap set to close on the front mount dizy. The tractor has been very hard to start when hot so I took the the dizy off to regap and retime when I put it back together the thing is running like $hit. The firing order is correct and there is plenty of fuel...
  10. B

    49 8n front mount

    Spring has been adjusted to the book. There are two kits on this site 1.Governor Repair Kit - Basic - For 9N, 2N, 8N. Kit contains gasket, lower race assembly, ball bearing, C-clip, 3 shims and 4 governor balls (58 inch). (Part No: BOK12502) 2.Governor Repair Kit, Complete - For 9N, 2N and 8N...
  11. B

    49 8n front mount

    I need to do some work on my governor. The throttle does not do anything for the first half of scale. What it do i need to fix this the $50 or the $100 kit thanks Bohinny
  12. B

    49 8n steering

    i have a problem with my front wheels turning to far and cuaseing me to backup or get off tractor to straightrn the wheels. the stops on the axle and spindel look to be in good shape. is there something i am missing?
  13. B

    Hydraulic system problem

    I just repaired mine which was doing the very same thing. upgraded the piston to the oring style and replaced the safey valve( to cheap not to while the cover was off). cylinder was in bad shape, filled all the bad spots with jb weld and rehoned and the lift has been up for over two weeks
  14. B

    Steering box grease

    Does TSC have a suitable grease for the steering box. I dont want to have to deal with the JD dealer for the CH grease
  15. B

    Trying to figure out what i have

    Thank you
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top