(800) 853-2651
SHOP NOW

Recent content by cookster

Yesterday's Tractor Forums
  1. C

    Oliver 80 rowcrop

    Is there anywhere to get engine parts for a 80? Pistons,sleeves and head gasket.
  2. C

    1650 water pump

    Is it same bolt pattern?
  3. C

    1650 water pump

    Can you put waterpump from diesel on a gas?
  4. C

    1650 water pump

    What is the difference between a gas and a diesel water pump on oliver 1650? Need to order one and diesel ones are lot cheaper than gas.
  5. C

    oliver 1600 hydraulic pump

    Thanks guys gives me a place to start.
  6. C

    oliver 1600 hydraulic pump

    Im looking at 1600 and the guys says the 3 point don't move and the power steering don't work. It is full on fluid. Any ideas? Does the pump run off a gear in the rear end or is it run off the pto shaft? If needs new pump how hard is it to find one?
  7. C

    Gemmer power steering seals

    Looking for seals for a gemmer unit on oliver 1800b. I found agco numbers 106959a and 107028as but can not find them. Is there other numbers i can use?
  8. C

    1800 shift fork

    yes it has hydra power
  9. C

    1800 shift fork

    The weld that holds the fork to the plate on shift rail broke. Can you get the fork and plate out to weld without pulling motor or hydraulics? Could it be welded in place? Any ideas would be great. Thanks
  10. C

    oliver 1800 B

    what is the point gap and spark plug gap for this tractor?
  11. C

    oliver 1800

    Bought a non running oliver 1800. The front wheels are turned a little bit. i tried turning steering wheel and it dont turn can i put a pipe between wheel and spindle to turn it or is there a easier way? Will it turn if you started moving it?
  12. C

    oliver 60 motor oil

    I got the motor loose on my oliver 60 now i need to know how many qaurts of oil it takes in the engine?
  13. C

    Siezed engine oliver 60

    Thanks for the help guys i got the engine loose. Now my question is how much oil does the motor take? Thanks
  14. C

    Siezed engine oliver 60

    I was wondering what guys are using to free a seized motor from sitting? Tractor was stored in shed for a few years and is now seized.
  15. U

    8N Won't Crank

    OK, charged the battery and changed the starter solenoid. The darn tractor just won't turn over when I hit the starter switch. Anybody with any ideas?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top