Recent content by dairyfeeder

  1. D

    John Deere 2640 Question

    I'm looking at a JD 2640 Tractor that got water in the Transmission via the shift boots. The owner says he flushed it out and got all the water out but now the loader it jumpy going up and down unless you rev it up a lot and the breaks are weak. The 3 point and power steering work fine also...
  2. D

    Farmall 460 Carb Problems

    I have everything on the carb set to factory specs, choke is closing properly and it has great spark. It has always been a very easy starter, full choke and about 3 spins and away it goes.
  3. D

    Farmall 460 Carb Problems

    I tried that didn't help.....
  4. D

    Farmall 460 Carb Problems

    They other day my Farmall 460 would not start which is not like it, I determined it wasn't getting fuel, I ordered a carb kit, took the carb off put a new needle and seat in cleaned the carb and put it back on, still won't start unless I take air hose wand and stick it down into tank and blow...
  5. D

    John Deere 566 Round Baler

    I'm looking for anybody's opinions and experiences with a JD 566 Round Baler, I'm looking at one to replace my Hesston 560 Round Baler. I have never had a JD Round baler so any info would be great.
  6. D

    JD 4010 Gas Cold Starting

    Oregon Cold.
  7. D

    JD 4010 Gas Cold Starting

    I'm looking for people's experiences with JD 4010 Gas and cold starting. I'm looking at one to get and keep at a stack yard we have that has no power at it to plug in a block heater. It runs very well and is well maintained, just didn't know how they did in the cold.
  8. D

    MF 1130 Clutch

    Thanks for the info, when you did it which half did you roll away, the front or the back? Thanks
  9. D

    MF 1130 Clutch

    I'm getting ready to put a clutch in my MF 1130 and I'm looking for a little advice or some pointers from anybody who has done one. Any help would be great, I have helped do a couple of JD 4020 but this is my first MF. Thanks
  10. D

    Hesston 560 Round Baler

    Thank you very much for the information, I'm going to do some testing as soon as I get it into the shop.
  11. D

    Hesston 560 Round Baler

    I recently bought a really nice Hesston 560 Round Baler from a guy that is having trouble with the tailgate going up, everything works fine on the baler except the tail gate won't raise. We have checked the basics such as fluid levels and can't quite figure it out, I have been told it's...
  12. D

    MF 1130 Clutch Adjustment

    I'm working on a MF 1130 that I recently bought that had the clutch pedal stuck down. I took the cover off underneath and the clutch is fully engaged(it will start and move in gear fine) I realized the clutch linkage was slipping on the shaft that comes out of transmission, I loosened bolt...
  13. D

    MF 1130 Battery

    Can anyone tell me what size battery a MF 1130 is supposed to have, I'm guessing a group 31 would be best but wanted to see what others use. Also did they have 1 or 2 batteries new?
  14. D

    MF 1130 Clutch Problem

    I just bought a MF 1130 tractor that has its clutch pedal stuck down, it will start in gear just fine and move freely but the pedal won't come back up. It shifts into all gears just fine as well. The guy I bought it from says he got on it one day and pushed the clutch in and it stayed there. Has...
  15. D

    JD 4010 Value

    I'm looking for opinions on what people think a 4010 Diesel with a bad PTO is worth. Tractor runs and drives great, sheet metal is all there and correct, good paint job, tires 50%. It's a nice looking tractor but makes horrible noise when you turn PTO on, inevitably it's going to need to be...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top