Recent content by E5

  1. E

    262 allis

    thanks everyone.change carb and manifold sounds like that would be a pretty simple upgrade to gain 7 hp.what about a little head work also,match manifold to head,valve job, might even shave little off head etc...any ideas
  2. E

    262 allis

    thanks for the input mike.the reason i was thinking about the 262 was i was wanting to make alot more power but i didnt want to ruin the 273 and you are right can,t find them no more.do you think a 262 manifold and carb would make a big enough increase in power to justify the carb and manifold swap?
  3. E

    262 allis

    thanks for the input does anybody know where i might be able to find a 262
  4. E

    262 allis

    ok i see you put the cs stuff on the allis motor duh! i dont know what i was thinking been a long day sounds like it wouldnt be to bad of a swap thanks
  5. E

    262 allis

    did you use the front and rear engine plates off of the allis
  6. E

    262 allis

    will a 262 allis bolt up to a 50 cockshutt i have heard it was a pretty simple swap i just cant bring myself to tare down the 273 budah it runs to good just thought i might be able to build a 262 and do a swap any ideas?
  7. E

    how many

    thanks matt just wondering
  8. E

    how many

    does anyone know how many cockshutt 50,s were made tractor data web site shows 3,974 but the serial#,s added up comes out to be alot more than that anyone know fer sure?
  9. E

    273 budah

    yeah maybe if i could find a crank.hard to find!havent hard about pushrods and rubberbands can you explain
  10. E

    273 budah

    going to do a valve job this winter. how much can you shave off the head on a 273 budah with out running into trouble.might regrind cam.does any one know what size dowle rod to use to hold up the lifters.might be interested in buying an allis 262 any leads would be appreciated
  11. E

    diet

    do they fit in the 40 spindles without any mods.
  12. E

    diet

    putting the old cockshutt 50 on a diet.has anyone replaced the front hubs on one of these 50,s to a lighter hub and if so what will work.thanks
  13. E

    wheel horse

    many thanks
  14. E

    wheel horse

    have a 1959 suburban looking for a cylinder head need one for the 5.5hp lawson any help would be appreciated.
  15. E

    cockshutt 50

    sorry i should have put tractor make in post.(cockshutt 50).the manifold i was looking at was off a d19ac.i assumed the exhaust hole was in the same place.is the carb linkage on the d19 on the same side as the cs50?
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top