(800) 853-2651
SHOP NOW

Recent content by ed cummins

Yesterday's Tractor Forums
  1. E

    Steering gear box blowing oil out the vent

    Ultradog MN...you seem to have some knowledge about this problem i am facing. do you know anyone who has replaced the steering sector gears?
  2. E

    Steering gear box blowing oil out the vent

    Those are the seals I replaced. Its #28 thats messed up and I am wondering if anyone else has replaced the steering arm box gears with the up dated ones. If so....did you have to replace the gear block on the worm drive. I have a feeling that the misalignment in the steering shaft is coming...
  3. E

    Steering gear box blowing oil out the vent

    Hello All, 1963 Ford 4000 with power steering. Thanks so far with all the advice. Here is another problem that I need tome advice with. I had to replace the steering arm (pitman arm) gears. One of the adjusting tabs was broken. That meant that I had to replace both because the new...
  4. E

    Rear Axle Knocking

    When you say the differential bearings and cups are you taking about the ones that hold the differential in place or the ones inside the differential. I replaced the outer ones but didn't take the actual differential apart.
  5. E

    Rear Axle Knocking

    I am sure they are tight because the 1/2 inch impact gun stopped moving...I have a big compressor and a snap on gun.
  6. E

    Rear Axle Knocking

    Hello All, 1963 Ford 4000. So after replacing all the bearings on the rear end and adjusting the axle spacing shims correctly there is still a knocking sound coming from the rear axles left and right sides when you shake the tractor back and forth. The harder you shake the louder the noise...
  7. E

    Power Steering Filter 1963 Ford 4000

    thanks....will try it.
  8. E

    Power Steering Filter 1963 Ford 4000

    Hello All, I am having a problem getting the correct power steering filter. The one I ordered from YT, and the one that the parts manual says is supposed to fit, is too small around. I went to Napa and they tried to get me close but that filter was too tall. Does anyone have a good part...
  9. E

    Ford steering sector gear

    Its the steering sector gear part #251294. If you are sitting on the tractor the steering gear lash adjuster faces toward the left. The pitman arm is on the right. Its for a 1963 4000 with power steering.
  10. E

    Ford steering sector gear

    Its the steering sector gear part #251294. If you are sitting on the tractor the steering gear lash adjuster faces toward the left. The pitman arm is on the right. Its for a 1963 4000 with power steering.
  11. E

    Ford steering sector gear

    Hi...anyone know where i might be able to get a used steering gear sector part #251294? Looking for a used one before I bite the bullet and buy a new one. Thanks Ed
  12. E

    brake travel question

    Hello All, Tractor: 1963 Ford 4000 Industrial with 134cu in engine. So I replaced all 4 brake pads and reassembled everything correctly and adjusted the brakes. My question relates to the brake pedal travel. I noticed that the cam that makes contact with brake shoes had a little space and...
  13. E

    hydro and rear diff fluid

    Hello All, The Ford manual I have does not specifically say which type of fluid to use for the rear diff and hydraulic. Just standard gear oil and standard hydraulic fluid? Regular gear oil in the tranny also? Its for a 1963 Ford 4000. Thanks. Ed
  14. E

    clutch throw and cotter pin leak

    4 cylinder 134 Cubic inch 4 speed tranny and the model # is 21201
  15. E

    clutch throw and cotter pin leak

    Hello, How much throw should I have on the clutch of a Ford 4000? Don"t know what clutch is in the tractor IE single or double clutch. Also I have a lot of what looks like tranny fluid leaking from the cotter pin/vent hole on the bottom of the tractor. I take it that the front tranny seal...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top