Recent content by JIM MALL

  1. J

    7120 hydraulic hose leak

    Well saw i got a hose leaking coming from under the cab. It looks like it goes to the oil cooler to front of radiator. Has anyone fixed one and how did you get to it.Any help would be great. Jim
  2. J

    JD 6 row 7000 planter clutch

    Is the shaft the drive clutch is on all one piece or is it split. Do you have to drive the shaft out past the clutch? Jim
  3. J

    2504ih no start.

    Pulled the 2504 out of shed to make more room.Left it running for about 20 minutes . Tractor been running good. Came out of shed it had died. Checked gas fine.Then checked for spark it had good spark still no start up. Could the condenser or coil be bad. Not sure what else. Any ideas. Jim
  4. J

    2166 caseih combine

    I got to put a new fan belt on the 2166 .What is the easiest way to replace.Do you need to remove the top sheetmetal that covers the motor.
  5. J

    looking for 1/4 inch canvas material

    I am looking for a piece that is on the feeder house on a 2166 ih combine. It is 36 inche by 2 1/2 inches. The material is 1/4 inch thick. Yes it is very similar to belting.
  6. J

    looking for 1/4 inch canvas material

    .Been looking on the internet for some 1/4 inch canvas. Anyone know of a supplyhouse or shop that may have some.
  7. J

    2504 IH tractor starter

    I removed starter just buzzing.Pulled it to find gear chewed up.Tractor has loader on it.So not much room how can you turn ring gear to check if its ok.
  8. J

    2540 ih

    Is there any good valve lubricant to keep valves from sticking.Seems engine not burning all the fuel.It loads up and wnts to die.
  9. J

    Paint for 7120 CASEIH

    Thanks for all the info.Going in the shop after planting done in spring.Jim
  10. J

    Paint for 7120 CASEIH

    Thanks for the help.So any automotive paint for plastic works with the Bulldog product?Jim
  11. J

    Paint for 7120 CASEIH

    What kind of paint would anyone use on the Caseih 7120.With most of it being plastic is there a special paint or primer.Thanks JIm
  12. J

    Sears 16hp overhead valve tecumseh

    I recently got this tractor the starter barely turns engine over.Brought starter to get checked out they said it was good.Could the solenoid be bad. The spins over ok'Looking for a little help.Jim
  13. J

    2504 ih

    Got new points set at .020 and new wires also new carb. When starting tractor it starts right up. It sputters a litle when throttle up.Seams like its running rich as a spurt of gas blows out of air intake at carb. Like its getting to much gas. adjust carb but no help.
  14. J

    Craftsman Gt 18 hp tractor

    I picked up this GT 18 hp tractor.It starts by key but its not wired to any kill wire.It has one at top of engine but goes nowhere.Trying to find wiring diagram towire to key switch.Thanks Jim
  15. J

    2504 IHi

    I am having trouble setting point gap help..I I got a loader on it and cant get to turn crank pulley. Any help.Thanks Jim
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top