-
JIs there anything as pretty as barley ready to cut? Spent the day cutting with my 955 slather. Sure wish it was going to yield as...
-
JJimB2 replied to the thread Intro post.Hi a photo I had taken at a fair that had some antique tractors, see the two head lights on M. My Uncles M had the rear light down...
-
-
JJimB2 replied to the thread IH 584 pto not stopping with clutch.If you don't have manuals for your 584 there are free PDF versions for the older version IH 54/74 series tractors at the following link...
-
JJimB2 replied to the thread Intro post.Welcome to YT, really good looking M, my uncle farmed with a 1950 M, it looked similar to your M but had two head lights a tail light...
-
JI don't know but I think if you can distribute the load then you would be better off. Something like this: A temporary beam spanning...
-
JThat tube is the CAMBOX OVERFLOW DRIP TUBE. It SHOULD BE LEFT OPEN, and NOT plumbed back to the fuel tank. Ford/Simms pumps had the same...
-
JJimB2 replied to the thread Case-IH 2200 Loader Hydraulic Relief Valve Shims D25844.Good to hear that you have plenty of weight on your rears. Dad also had calcium loaded tires and if he was doing heavy lifting with the...
-
JJimB2 replied to the thread Case-IH 2200 Loader Hydraulic Relief Valve Shims D25844.Back in the late 1960s early in 1970s, Dad had an IH 434 with IH 1501 loader and neighbor had the same tractor loader setup. Neighbor...
-
JJimB2 replied to the thread Case-IH 2200 Loader Hydraulic Relief Valve Shims D25844.Here in Canada, our local IH Mechanic at the time said just use a Canadian Dime (10 cent coin) as a shim behind relief valve on IH 1550...
-
JJimB2 replied to the thread "New" B-275.His B-275 has the older CAV inline pump like the B-250 and the part that is leaking is the feed pump and the hand primer. Usually they...
-
JJimB2 replied to the thread International b414 hydralic oil coming out of filler neck.I see you have a late model B414 as it has the hydraulic drain plug at the bottom of reservoir below the filler hole. I see you have the...
-
JJimB2 replied to the thread "New" B-275.Could be causing excess back pressure on the input side of the feed pump or the valves inside the feed pump are not opening and closing...
-
-
JJimB2 replied to the thread International b414 hydralic oil coming out of filler neck.Is the filler hole behind the seat on top of the hydraulic reservoir or another auxiliary hydraulic tank? If it is the filler plug...
-
JJimB2 replied to the thread "New" B-275.Have you changed the fuel filter lately?
-
JIm back. My computer died a while back. I just bought a new laptop.I'll try to pick up where I left off. Missed you guys. Steve
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy