-
J
lift cylinder
8n 1951 the 4 bolts for the lift cylinder.. how tight should they be or what Torque- jupton
- Thread
- Replies: 3
- Forum: Ford 9N, 2N & 8N
-
J
8n not charging right
Thanks dell & soundguy I will Take,m both in to auto parts for a test. Jeff (TN)- jupton
- Post #1
- Forum: Ford 9N, 2N & 8N
-
J
8n not charging right
I have a 51 8n sidemount Dis. 12v con. that is letting water come out from under Bat. caps and run down the side of the tractor looks like white powder,y stuff .. also when i volt meter the Bat. i,m only charging 12.3 to 12.5 volts with tractor running . I get the same thing on the one wire pole...- jupton
- Thread
- Replies: 3
- Forum: Ford 9N, 2N & 8N
-
J
641
old : I ajusted carb just like you should .. idel is good takes gas good runs strong when bushhog,n better then it has in mouths he said after i ajusted carb .. it was out of ajustment bad .. I even set carb with bushhog running for the load at high speed.. the high speed needle is only 1 1/4... -
J
641
This 641 is putting gas in the oil pan ,sooo I thought he had forgot and left the gas on, so I checked the shut off by taking it lose at the carb all was good there so we change oil (again) work tractor bushhog about 30 mins works good put tractor back in barn.. This morning check oil level and... -
J
gas tank
Just did some repairs on my gas tank .you guys doooo.. paint the gas tank before puting it back in Right??? Jeff- jupton
- Thread
- Replies: 3
- Forum: Ford 9N, 2N & 8N
-
J
Gas tank liner / coating
Thanks for all the info guys... Jeff- jupton
- Post #1
- Forum: Ford 9N, 2N & 8N
-
J
8N Gas Tank - Second Time Around
Thanks for the replys, You got me thinking a new tank would be nice.. "no repairing old tank" LOL Thanks guys fro the info.. Jeff- jupton
- Post #1
- Forum: Ford 9N, 2N & 8N
-
J
Gas tank liner / coating
52" 8N sidemount dis. OK guys had to take tank off because of rust in the tank. what i would like to know is what to put in the tank to rattle around to clean rust from the tank before liner go,s in ??? Bottole said put rocks or bolts & nuts with hot sope,y water.. If someone has any tips ...- jupton
- Thread
- Replies: 10
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy