(800) 853-2651
SHOP NOW

Recent content by mpdhorsecop

Yesterday's Tractor Forums
  1. M

    Battery Drain

    Everything is good! Battery was still charged this morning. Man! Gotta cut grass now. Forgot about that. Thanks fella"s.
  2. M

    10SI alternator spade question

    Bob that's a great shot! I appreciate it. Confirmed my wiring too.
  3. M

    10SI alternator spade question

    I had them right John. Just wanted to be sure. Got spooked when I saw those letters below the #'s. Had a bad alternator and the NAPA guys swapped it out after testing. Got the new one tested before I left. (advice from Sounder) Hit the switch, light came on, started'er up and the light went...
  4. M

    10SI alternator spade question

    OK. I got the new alternator but just for safety sake I have a question. Looking at the back of the alternator; with the plug in connector on top; the two spades left to right, starting with the left connector, it is marked #1 on the housing and "N" right below it. On the right spade, #2...
  5. M

    Battery Drain

    Had it checked today. Diode in trio gone. I'll pick the replacement up tomorrow and "old" I'll follow your advice, it'll be checked before I leave.
  6. M

    Battery Drain

    I"ll get it checked this afternoon. Thanks
  7. M

    Battery Drain

    Howdy old. It"s a 10SI Delco. Oh trust me, wire by wire it"s hooked up right. jnla made sure of that.
  8. M

    Battery Drain

    I got everything back together on the 800 and when I attempted to start the engine found the battery dead'er than a hammer. Put the charger on it and it fired up. Got back from Nawl'ins two days later found the battery dead again. I had it checked and was ok before I put everything back...
  9. M

    Took'r for a Ride.

    After getting the wiring done on the 800, which turned into replacing the battery box, starter, fuel tank and exaust, I just couldn't help but fire it up and take it around the property for a little bit. Still don't have the heat shield in yet so i couldn't put the cowling back on. Didn't...
  10. M

    Gas tank fire - almost!

    Man! That'll make ya change your shorts! Would me! Glad to hear there wasn't a mishap!
  11. M

    Fuel shut off for Working 800

    soudguy, read you got a new project. Congrats! I read on an older thread that you posted on were you put a short sed. bowl with a cut off to the sed. bowl on the carb. Tried finding it again but couldn't. I've already insalled the old shut off valve with a new O-ring. Greased up the inside of...
  12. M

    Fuel shut off for Working 800

    I"ve read about the shut off valve, seen the shut off valve, changed the shut off valve. Know that the screw in, or lever type will fail, eventually. Read about changing o-rings and drilling out pins and routing lines every place. Believe the shortest distance between two points is a straight...
  13. M

    Had enough, need best 12 volt conversion kit for NAA

    Just re-did mine with jnla"s help, diagrams and such. Easier than you think. Didn"t buy the kit but if you do, use the harness that comes with it to tie up tomato"s or something. It"s worthless.
  14. M

    Hydrolic fluid recommendations For An 800

    Thanks guys. Got some today.
  15. M

    Hydrolic fluid recommendations For An 800

    Couldn't find any recommendations for hydrolic fluid, probably is but I couldn't find it. I read that it could be purchased at TSC or Walmart but no brand or specs mentioned. Never been steered wrong here. Thanks fella's.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top