(800) 853-2651
SHOP NOW

Recent content by oregonfarmer

Yesterday's Tractor Forums
  1. O

    Engine will not turn over on my 820 3 cylinder made in Germany

    Thank you all but my problem seems to be deeper than just a starter problem. I can't move the PTO. Is it possible that the disc brakes are locked up?
  2. O

    Engine will not turn over on my 820 3 cylinder made in Germany

    Tractor was running fine and the next time I tried to start it it seemed locked up or frozen. I don't know why because it had been running just a few hours before. Any ideas?
  3. O

    Farmall 200 ignition problem

    My Farmall 200 has a problem. I was driving it when it kind of sputtered a few times and then stopped, and it will not start again. I checked the timing and wires, etc. I had a new distributor and installed it and that did not solve the problem so I checked the coil and I have 6.2 volts...
  4. O

    1 wire alternator

    I want to install a one wire 6 volt positive ground alt on a 200. There are so many it is hard to know witch is best. This tractor has only starter and ignition to power.
  5. O

    pluged injector lines

    anyone know how to open injector lines? Ihave tryed many things no luck...
  6. O

    glow plugs

    how to install glow plugs
  7. O

    Farmall C steering gear

    Having problem removing steering shaft from the steering box. I am trying to install a new bearing on the shaft but can't push it out.
  8. O

    Buying fuel injectors

    I have searched the net for injectors for my 3cyl 820. There are so many and it is confusing as to which are the best choice. Perhaps someone has experience and could offer some pros or cons on buying injectors online?
  9. O

    820 JD 3cyl roosa master injection pump questions

    My 820 just went dead while mowing and refuses to restart.I bled the system, cleaned the return lines and tank return valve.Fuel gets to pump and up to returns,but has a weak flow. The shut off solenoid is OK. I suspect an internal pump problem. The number tag has a AR.....but I don't see...
  10. O

    Super H starter problem resolved

    This is a thank-you to all of those who answered my post about the Super H starter. All the suggestions were good and what finally solved the problem was larger battery cables. I removed the #2's and installed #0's and now it works fine!
  11. O

    Super H starter weak

    I have used this tractor for many years and it looks and runs great. The problem is the starter. It was replaced, but was no better than the one it replaced. The best new battery that would fit made only a slight difference. A new starter switch didn't help either! You have to run the starter...
  12. O

    perkins 3cyl piston liners

    when removing the cast liiners from Perkins 3cyl I nicked the block bores. Could I use epoxy to fill in and hone the walls? Or have I ruined the block?
  13. O

    820 injection pump

    Thank you to all who answered my post. It was a blocked return line. As my compressor was not near, I blew it clear by mouth!! All who replied knew what my problem was. I have had questions on other forums and have had answers from members who had no idea how to help but for some reason felt...
  14. O

    820 John Deere diesel starting problems

    My 820 3cyl has a problem. It started out by starting up and then stopping about 10 seconds later. This repeated until the battery got very low. I changed fuel filters and bled the system but it would not start at all. In desperation, I gave it a shot of starting fluid and it fired up. It ran...
  15. O

    IHC hay balers

    I have owned several balers made by International and they all worked fine. They get bashed by many and to them I say: anything can be fixed if you try and have a manual! One IHC baler that I have never seen is 425. The flyer for this model shows a "Deering knoter" and several items that differ...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top