(800) 853-2651
SHOP NOW

Recent content by polaschd

Yesterday's Tractor Forums
  1. P

    What series JD Crawler??

    Can anyone tell me what Model of John Deere Crawler this is? I believe it to be a MC but the blades doesn"t seem to be correct,
  2. P

    Ventialtor pump removal 49 B

    Not having a press what is the next best way to remove the ventilator pump from a 49 b
  3. P

    will not stay running 49 B

    Read the reuest for help I believe I mentioned that I was using the service manual if you have no good comments or help stay out of it
  4. P

    will not stay running 49 B

    I have just finished putting the engine back together after a rebore .90 I can get the engine to run has good compression but when I take the choke off the engine sputters and dies. I rebuilt the carb and reset the idle and the load needle as directed in the sevice manual still no luck. When I...
  5. P

    49 B John DeereTorque for connecting rods

    What is the proper torque on a 49 B john deere connectiong rods?
  6. P

    49 B Problems

    Yes, they were at TDC> I understand it was a mistake not to take down further I got It! I am seeking advice on how to do it right no plans on selling this is a family tractor. Again why during the pressure test am I getting air push through exhaust on right and on left the push(hiss) goes back...
  7. P

    49 B Problems

    Yes they did grind and lap this guy is quite familiar with 2 cylinder heads. My confusion is the compression readings and the when I push compressed air in the right side 0 psi at tdc all air escapes from exhaust on left side 30 psi i am gettting minimal escape through the exhaust but can hear...
  8. P

    49 B Problems

    true but why would the cylinder that showed 30 psi when testing the compression blow the air back through the cylinder and the one with 0 psi push all the air through the exhaust?
  9. P

    49 B Problems

    I have been rebuilding a 49 B, Engine was stuck but I was able to unstick with minimal effort. I did noot take the cylinder off and check the pisotns and rings, I did however have the head check by a local shop and they cleaned and confirmed it was okay. After putting it back together and...
  10. P

    49B John Deere Timing

    Thanks I did not remove the crank and cam everything seemed to be alright with them however I have removed the clutch pulley and would like to remove the flywheel for repainting books seem to be a little confusing email is [email protected] thanks Dean
  11. P

    49B John Deere Timing

    I have most of the tractor disassembled. As I put it back together can it be timed without the flywheel cover intalled. i.e. replacing the governor and fan shaft assembly etc. Thanks for any advise Dean
  12. P

    Oil Filter Body on JD B

    I need to replaced the rod in the oil filter area. I tried to turn it out but it would not come out. The only thing I can see is that the the Oil Filter Body has to come out How do I get this item out w/o damaging it.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top