(800) 853-2651
SHOP NOW

Recent content by TP in IA

Yesterday's Tractor Forums
  1. T

    case 1840 skid loader

    my skid loader won't start ,starter won't kick in , new rebuilt starter from hi quality shop,battery is 1 1/2 yrs old , ignition relay new ,when key is turned on dash turns on but buzzes but nothing happens ,checked vatage at starter it is 12&amps any suggestons what is wrong ?THANKS
  2. T

    jd 3010 gas

    THANKYOU for the information TP
  3. T

    jd 3010 gas

    where is the gas shut off valve located on my 3010 gas tank
  4. T

    john deere 3010 gas

    where does the wire with the in line fuse hook to on the starter? i had the starter rebuilt had all the wires taged as to where to hook back exceot the one with in line fuse , I have another question soon thanks
  5. T

    case 1840 skid loader

    thanks guys i will try the suggestions 1st of the week TP
  6. T

    case 1840 skid loader

    I have a 1840 which just up and died while using it, .the engine switch dose nothing so here is what i have did- new battery- both line fuses - new key switch when we lower the instrment panel found a mouse had chewed some coating off of some wires so repaired all that had been chewed...
  7. T

    560 gas hed gasket kit

    THANKS Guys i really appreciate the information TP
  8. T

    560 gas hed gasket kit

    starting to get ready to replace the head gasket , my question has anyone used NAPA gasket kit fpghs7799cs2 by fel-pro ( 1958 model 560 )thanks
  9. T

    farmall 656

    i've got water in my hyd system . Trying to drain all of the oil out ,what is the cover ahead of the drain plug its aprox 3 x5 when i took it off there was all kinds of sludge there. Thanks for all replies TP
  10. T

    farmall 95

    Needing a new battery for my farmall 95(2012) it now has a17H1 NAPA in it ,what are some other that will fit also # of it THANKS
  11. T

    farmall 560

    I have the gas tank loose and raised (over engine) 4 under tank is a shield over the motor it is factory spot welding in both sides at the back corners ,do i cut the welds loose with a small chisel my serial # 33916 thanks for all info replies
  12. T

    farmall 560

    i have a 560 gas which is getting water in the oil. i have removed the sheet metal and hoses . next loks like manifold needs off ; do i need to remove the gas tank to be able to take the head off? and what else need to b taken off ? this is my first project on a 560 THaNKS
  13. T

    electronic ignition

    what is the difference of pertrnix 1247xt and a 1247xtconn electronic ignition ? i ordered a kit and it came 1247xtconn it did not have any of the ignighter parts all i got was dist cap the fiber cover 12v external coil coil clamp and a coil wire small packet of screws and washers THANKS FOR...
  14. T

    building big round bale trailer

    building one 3 on each side 2 in front and 1 behind axel
  15. T

    building big round bale trailer

    How wide(far apart) should i space the bale carrier arms ? bales weigh around 1200 to 1400 pounds plus or minus thanks
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top