(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. J

    5635 transmission problems

    Can someone tell me if I have to split the tractor at the bell housing to get to the manual shuttle forward and reverse on a 5635 ford/new Holland or at the rear end? Tractor has reverse but has no forward gears. I’ve ordered a repair manual but would like to go ahead and get it apart while I’m...
  2. J

    M@W dyno parts

    Anyone know where I could get a tach for a P400 or someone that could repair my tach? It spins but there’s a spring broke inside.
  3. J

    3010s key switch wiring

    Does anyone have a wiring diagram for the key switch for one of these. I bought it not running they’d tried replacing the switch and cut wire ends off. There’s one that has two wires I think they may have put it with the wrong wire.I’ve seen all the pictures of how to hook it up but that doesn’t...
  4. J

    8n lift problems

    I’ve got a 8n that’s got lift issues. The lift raise up when you put the pump in gear and won’t go down regardless of where you put the lever. It’s got a few worn pieces I’ve replaced the pin that rides on the cam. Question is does that still relate to something in the cover or something with...
  5. J

    2640 Charging Proublems

    I’ve read and read about others with the same problems but haven’t seen really anything about the fixes. I’ve got a 2640 with Motorola alternator that has separate regulator. I’ve had alternator checked ( everything good) and put a new regulator. It won’t charge any but I don’t have power on...
  6. J

    Oliver 1850

    I need to replace the water pump on a 1850 with a Perkins diesel. I looked it up on AGCO and it must be showing one for the Waukesha engine . I found some if I look them up for a Perkins engine. My question is are they the same if I look it up for the engine versus the tractor? I know they show...
  7. J

    730 D electric start electrical problems

    It’s a 730 D electric start with flat top fenders. Trying to get the 4 fender lights and dash lights to work but I don’t have any power. I’ve read numerous posts on this. Does anyone have a picture or diagram of how the 2 batteries should be hooked for it to work? I’ve seen some with 4 batteries...
  8. J

    4630 wiring harness

    Does anyone know where I might be able to get an engine wiring harness for a 4630 part number 82003481? New Holland says no longer available. Had a fire and pretty melted all of the harness to where it plugs under the fuel tank.
  9. J

    5400 Transmission or rear end popping

    I’ve got a 5400 that in road gear pops and jumps a little when it has some pressure on it like starting up a hill. It almost feels like it slips a gear but there isn’t anything broken or missing anywhere or any noticeable wear on anything. I was told that there was a problem with some early...
  10. J

    2630 Engine oil

    Can someone tell me how much engine oil a 2630 holds? I just rebuilt the engine and went buy the shop manual and it is just to the add make after 2 1/2 gallons. Just wondering if I need to keep poring or is the dipstick the wrong one? This manual says 10 qts but not enough if stick is right!
  11. J

    543 Massey Injection pump and Engine timing

    I’ve got a 543 I need to remove the injector pump to have it rebuilt. How do you get the engine timed so I can pull the pump. This pump has the bolt to lock it in place and also has a key way in the shaft but gear does not have a key way slot. I’ve not found any timing marks on the flywheel or a...
  12. J

    Big Ox Finish Mower

    Anyone have an idea of where to order some blades for a Challenger 2 Big Ox 4ft finish mower? These are counter clockwise 16 1/4 long 2 3/4 wide with a 3/8 hole in the middle and 3/8 wide x 1 1/2 long slots on both sides of the hole. Thanks if anyone can help!
  13. J

    Needing finish mower blades

    I’ve got a big ox challenger 2 4ft finish mower and need somewhere to get some blades. I found a place once and lost what I wrote it on and can’t have any luck finding them now or anywhere to get any. If anyone can help or knows where?
  14. J

    Timing a 4630 pumps

    Can someone tell me the right way to set injector pump timing on a 98 4630 with the later DPS style pump? What degree I need to set flywheel on and so forth. I know the pump has to be set at a shop but can’t find much info on these later pumps on what to set engine degree on to install the...
  15. J

    4610 steering cylinders bent

    4610 is bending steering cylinders both sector gears are right arms etc. nothing looks to be replaced except power steering pump I put on. I dont have a manual for these I have one for 1000 series and it says the cylinders should stop short of steering rod hole before spindles hit stops. I...
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top