(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. W

    Push button start switch

    My Jubilee has been running fine, when to start it today and got nothing when I pushed the start button. Could the problem be the start button or maybe the relay? How do I test this problem. Thanks for any help, Earl
  2. W

    NNA Jubilee, Re Start Problem

    I can work with my Jubilee for an hour or more. Been dragging my 6' rake on our gravel roads. BUT!! If I turn it off I have to wait about 20 minutes before she will restart? Really afraid to go to far from the house with the restart problem. Any Help Please..... WVKid, Earl
  3. W

    Tachometer, NNA 1953 Ford Tractor

    I got a new timing light but not sure where 450 and 2200 RPM's is on the Tachometer. The tachometer shows the RPM's for 1st gear, 2nd gear etc. but with the shifter in neutral is that the same readings? Want to check the Static timing and engine high idle RPM's. Don't think I'm asking...
  4. W

    Timing Light - Ford Jubilee

    I need a timing light..... Found good prices on EBay but most state that they for 12 volt engines. Would they still work on 6 Volt tractors? Thanks, WVKid
  5. W

    Jubilee Defferential

    How do I check the fluid level in the defferential, there is no dip stick and I don't see an over-flow bolt to check level? Spec's call for 8 quarts.... Thanks, WVKid
  6. W

    NNA Jubilee Update

    Hello Gang, Thanks to everyone for all the help and advice. She is running good and no leaks. Got the cotter pin back in and it does not drip as it did before. There was almost 8 quarts of gear oil in the trans. pan when the spec.s call for 6 quarts. New O rings fixed the leak from the...
  7. W

    Cotter Pin in Transmission pan?

    Wow!! The stuff I don't know about my NNA. lol I have a hydraulic oil leak in the bottom of the transmission pan and it was putting a nice puddle of oil on the driveway. I saw it coming from a cotter pin and said what the sam hill is it doing there? I go it out and coated a screw with...
  8. W

    Thank you note to:

    Jubilee NNA Hi guys, just wanted to say thankyou to: souNdguy, Royse, ericlb, Bruce (VA) and anyone else that has helped me with my timing and starting problems. I finely got the timing set and with the roter pointing at the #1 plug hole. She fired up one the first crank and is running...
  9. W

    Jubilee NNA Hydraulic leak

    I have a small leak where the hydraulic lines connect back toward the rear under the bottom of the tractor. Before I remove the one line that's leaking, I wanted to know if there is a gasket there. Can it be ordered or just make one from gasket material. Thanks, WVKid
  10. W

    Ford NNA, Starter motor arcing

    My Jubilee starter mortor is arcing at the cable connection. Had just installed a new drive assembly on the starter. Was cranking the motor a few times to check it, fuel was off, wasn't trying to start it. Turned it off to get some help as to why it's arcing. Thanks, WVKid
  11. W

    Engine Timing help, Please

    Just found the 31 degrees mark on the flywheel. My Rotor cap is pointing straight ahead toward the front of the tractor and not at the #1 plug as it should. I'm a little lost at this point because my book tells me to temporarlly install the distributor and rotate the breaker cam in normal...
  12. W

    Jubliee carbuerator problem

    Hello guys, I was trying to start my NNA Jubilee after checking points and plug gaps. Was getting good spark and after about two minutes of cranking the carbuertor back fired, had the fuel flow open two turns. Had the air cleaner hose off the carb. at the time. So loud it made me spill...
  13. W

    Jubilee - Slow cranking speed - low RPM's

    Working on my Jubliee, been sitting for two years. Rebuilt generator, carb. many new electrical parts. Put in new 6 volt battery and wanted to see how fast she would crank. I"m getting very low RPM"s when cranking. Wondering if I need to rebuild the starter motor? I used my pickup (12V) to...
  14. W

    Coil hookup, Ford Jubilee

    On the plus and minus side of the coil, which side hooks up to the distributor? One wire goes to the ingintion switch and one to the distributor, right! Would I do any damage using an 8 volt battery on a 6 volt system? 1953 Ford NNA Jubilee Thank you, WVKid
  15. W

    How to wire coil and ignition switch, 1953 NNA Jubilee

    Not sure if I have wired the coil and ignition switch as it should be? Any help please, WVKid :(
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top