(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. H

    Allis Chalmers WD Water in Oil

    I have 1952 WD, it had been getting water in the oil, I've ruled out the head gasket and freeze plugs in head, it seems like its getting around the o ring on the sleeves, minus this issue it starts and runs good, no smoke or bad sounds. I was reading that some will use aviation sealer around the...
  2. H

    Wd hydraulic pump help

    I have a 1952 allis chalmers wd, the hydraulic system was abandoned years ago, i am wanting to go through it and get it working again. I figured rebuilding the pump would be a good start but im having a heck of a time finding a rebuild kit for it! Does anyone have an leads on a rebuild kit?
  3. H

    Ford 2000 throttle not staying put!

    I have a 1970 ford 2000, the throttle will not stay put, it has been likely rigged and worked on long before me, ive installed a new friction disc and spring and still doesn't like to stay put. It almost seems that the governor is able to easily over power the throttle friction disc, any help is...
  4. H

    Ford 2000 throttle lever help

    I have a 1970 ford 2000. The throttle lever has never stayed put. I've always had to hold.it or bungee cord it. It doesnt really have a friction disc, just some kind of rubber washer that doesnt work. Does anyone have a picture of what the setup should look like or maybe a homemade setup? I just...
  5. H

    Ford 2000 clutch replacement advice needed

    I have a 1970 ford 2000. It has the dual stage triangular clutch. It's completely shot. I've got my tractor split and have the clutch out. Where is the best place to get a clutch kit? I dont wanna do this job again. Also does anything need adjusted on the clutch when I install it? I seen it had...
  6. H

    Ford 2000 two stage clutch problems!

    I have a 1970 ford 2000 gas. I've never been able to get the 2 stage clutch to work. So I tore it down far enough to get the steering tower off to adjust the clutch internally. This is what I found 2 of 3 adjusters are broke !! Is this repairable in the tractor or is it time for a...
  7. H

    Ford 2000 alternator conversion

    So after testing my charging system I determined I had a bad VR. I replaced it with a new one and still issues. I decided to go with a chevy alternator and do away with the generating system. I have a good alternator and I've found I can buy the tach drive from yesterdays tractor for 27$...
  8. H

    1970 Ford 2000 Not Charging

    I have determined my tractor is not charging, im getting 11.9 volts on the battery no matter what rpm. I need help in testing the generator, i seen it has a large and a small spade on it. If possible ide like to test the generator, i figure it has to be either the generator or voltage regulator...
  9. H

    Ford 2000

    First post ! Just bought a 1970 ford 2000 with live pto. I am having trouble with the clutch, with the engine running and clutch to the floor the pto will not engage I have to engage it then start the engine. I can feel the pto part of the clutch towards the bottom it's almost like I run out of...
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top