(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. B

    1948 8n 12v front distrib. weak spark

    We just fixed a weak spark on my neighbor's 8N by replacing the plug wires with solid wires. Are your new wires solid or resistance?
  2. B

    OT: IT

    I don"t Think you will find any that are 100%. After years of worrying with this question, would you believe that my prime computer is using Windows 7, and the software it provides. Have had no problems so far. I think the more important aspect of this problem, is to try and not get a virus...
  3. B

    left over part

    Looks like the retainer ring on the rear wheel hub nut.
  4. B

    '52 8N Generator problem (from couple of days ago)

    Well, that sheds some light on the subject. Thanks!
  5. B

    '52 8N Generator problem (from couple of days ago)

    The other day, I was talking about my neighbor's 8N was not charging. We found that the generator would motor, but would not put out. The neighbor took it to a shop, where they put new brushes in and perhaps did other things. They put it on their machine and showed him that it was putting...
  6. B

    '52 8N Generator problem

    Thanks JMOR. I had tried changing the polarity, and there was no change. I guess that means there is field current. I will try removing the field current connection and look for a change in speed. If there is field current, then why do you think it is running backward?
  7. B

    '52 8N Generator problem

    My neighbor's 6V Neg ground system. The wiring looks real good. It was not charging. The generator was not putting out. We disconnected all wires to it, grounded the field to the generator ground terminal, and it still had no output. We disconnected the belt, grounded the field and applied...
  8. B

    '52 8N Ignition

    This my neighbors 8N. It is the original 6V system. It has been sitting for several months, but seemed to run OK before. Now it will not start. We saw that it had a weak spark, so we re-worked the ignition ckt. Now we have a nice blue spark. The trouble is that it will not spark every...
  9. B

    Distributer Question

    '51 8N side distributor. Opened up the distributor and found the rotor button in a few pieces. All the metal was gone. This could have happened when someone looked into the distributor earlier (another story). Two questions: 1. Could the metal parts get behind the floor plate and cause...
  10. B

    OT,,, Old time remendy

    Back around 1940-1950, my g-mother made a drink with orange juice, onions, and castor oil and other possible things. It was cooked on the stove. Bad stuff! Also, she made what was called a "Muster plaster". Don"t know what was in it, but it would burn you up! She (or my mother) would slap...
  11. B

    OT - Old Bolens Husky FMC Sickle Mower

    I can not find any information on this mower/Tiller. I was hoping you guys would know something. It is a right neat old machine, with attachable sickle mower,tiller tines, and about a 3 HP 4 cycle Briggs. I think it would be from about 1955. The Briggs looks about that age, but still runs...
  12. B

    The drain

    Yes, I know the difference. Happen to have both. But I think batteries is batteries.
  13. B

    The drain

    I had the same trouble (12V 8N). It was the battery. It would seem to be charging, but would not hold the charge.
  14. B

    '51 8N Governor rework

    Got me a kit. The 8N would not idle low. I have the governor on the bench, and sure enough the balls had flat spots. Now, before I tear something up, I Thought I"d best ask a question. I"m looking at the FO4 manual, and it does not show anything holding the drive shaft to the drive gear. It...
  15. B

    '49 8N QUIT

    Yesterday, I posted that my 8N, after about 3 min. quit. Today, I cranked it an it started and ran fine for 1 min., then it quit. I could not get the bolt at the carb because it was somewhat rounded, and at 71 years, I didn"t feel like standing on my head to work on it. So I disconnected...
  16. B

    '49 8N QUIT

    Thanks guys, I"ll get back to you next week.
  17. B

    '49 8N QUIT

    Yesterday I started the 8N. It started great. Then, after about 3 min., it quit with no special sounds. Kind of like turning off the switch. Gas was turned on and there was gas. I just walked away from it. Sounds like something to do next week. What do you suppose happened?
  18. B

    a small set back in life

    I had a stroke about three years ago. It affected my left side. I also could not put things in alphabetic order, write a check, figure out what month it was and some other things. Things have gotten much better, and I suspect you will see a lot of improvement also. Be patient. Most of it...
  19. B

    1958 Deere 320 Runs Rough

    Thanks Ray, I guess the man that sold me the thermostat either didn"t know or wanted to make a sell.
  20. B

    1958 Deere 320 Runs Rough

    From the archives, I see other people have had similar problems. After about 5 minutes of work, the 320 starts to run rough. It has always been hard on plugs, but would run. this problem has just started. I read that the two lung engines tend to run cold, and so I got a thermostat. The...
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top