Farmall B - plow (bracket?)

[DoubleJFarmsWA]

Here is my B, it has most of the plow linkage (and is setup with exhaust lift). In the photo, there is a blue arrow that I drew in, does anyone know what the bracket looks like that connects there? I assume it goes to the axle (as most pics I have seen, show the drawbar removed when the plows are attached.)

 

[560Dennis]

I would contact Steve Smith , he has a lot of books on ihc plows . He advertises plows, parts here. Hes in republic Ohio.

 

[mschwartz]

I think I have that setup for a single plow for the exhaust lift on a Farmall A at my house I will try to grab you a couple pics or you can run
out and look sometime. I think it is a pair of flat straps that bolt to the axle housing and have a hole large enough for the round shaft to pivot
in. Are you going plowing Saturday? Mike

 

[gene bender]

is that the one that bolts to the final then to the rockshaft give me the
dimensions and size of the hole for the rockshaft i have over the yrs had
three of them email [email protected] or call 319 430 3907

 

[DoubleJFarmsWA]

(quoted from post at 21:41:38 10/19/23) I think I have that setup for a single plow for the exhaust lift on a Farmall A at my house I will try to grab you a couple pics or you can run
out and look sometime. I think it is a pair of flat straps that bolt to the axle housing and have a hole large enough for the round shaft to pivot
in. Are you going plowing Saturday? Mike

The B isn t ready, and our cub that has a plow is (but it s my wife s, and she s busy this weekend) and I don t want to break it. But I may go and watch.

 

[560Dennis]

Moldboard left broke ? I had one fractured in about same spot . . Welded it to fix

 

[mschwartz]

Pics of what my A uses, I suspect B will be similar

 

[DoubleJFarmsWA]

(quoted from post at 13:45:55 10/20/23) Moldboard left broke ? I had one fractured in about same spot . . Welded it to fix

Yeah, I have the broken piece, so plan to weld it back on.

 

[560Dennis]

Forgot to mention I preheated my moldboard before I weld it . With the soft steel center(harden outside ) , thought it would cool more even
after welding .

 

[DoubleJFarmsWA]

Well, I got back to the project for a bit.