having trouble with clutch linkage 8n ford

[Gary Singleton]

Had to replace my starter ring got that done also put new clutch In now need to adjust>and can't get pins out finally got one but that's all any ideas 8n ford thanks Gary

 

[Roger in Iowa]

After removing cotter, turn pin 180 degrees, then pull out.
Pin will be well worn and cannot pull out without turning.
Replace worn pin.

 

[Gary Singleton]

Tried that can't get them to turn at all got one out but had to buy strong paint remover to get it hard to reach

 

[Eman85]

There's one pin with a cotter pin in it. Spray some PB Blaster or similar magic on it and after it soaks hit the head of the pin and pry it back with a small bar. Once it breaks loose you can rotate it.

 

[Gary Singleton]

Thanks I will try it Gary