I am restoring a 1945 UT (KEF engine) that was left outside to be tampered with. As a result I do not know where the temperature gauge was suppose to connect to the cooling system.
Is it the pipe fitting on the water pump housing the arrow is pointing to here?
I have a reproduction of an original MM temperature gauge that I got from from Tisco. It has a 40 inch tube with the thermo sensor that inserts into the cooling system. The end of the tube only reaches from the dash to just in front of the rear of the engine. I do not see any location at the rear of the engine to connect it into.
Thanks for any help with this question.
Is it the pipe fitting on the water pump housing the arrow is pointing to here?
I have a reproduction of an original MM temperature gauge that I got from from Tisco. It has a 40 inch tube with the thermo sensor that inserts into the cooling system. The end of the tube only reaches from the dash to just in front of the rear of the engine. I do not see any location at the rear of the engine to connect it into.
Thanks for any help with this question.