(800) 853-2651
SHOP NOW

Recent content by brownell3387

Yesterday's Tractor Forums
  1. B

    Ford 3600 3 point won't raise

    I pulled the plug on the top of where the remotes would be coming out of if this tractor had remotes and it is pumping fluid out of that plug but I m still only getting 1in of lift on the 3 point
  2. B

    Ford 3600 3 point won't raise

    Nothing happens. I only get 1in of lift if the draft is all the way down then position all the way up
  3. B

    Ford 3600 3 point won't raise

    It has 1 for position and 1 for draft
  4. B

    Ford 3600 3 point won't raise

    just bought a ford 3600 with loader, loader has its own pump run off crank, the 3 point on the tractor will only go up about an inch if the draft control leaver is in the down position, my 3600 has I believe the gear driven pump with the spin on filter right on top of the pump. I have tried...
  5. B

    Sos sawp

    So will the 841 fit a 971 This post was edited by brownell3387 on 07/10/2023 at 05:52 am.
  6. B

    Sos sawp

    Hey guys I am wondering will the transmission out of a 841 power master swap in to a 971 with the sos? If so what all will I need from the 841 to swap it over?
  7. B

    Ford 3000 hydraulics

    So my 3 point and remotes work but sometimes they stop working and if I tap on where the position leaver goes into the top plate everything starts working again I didn t know if something inside was gummed up and a flush would help
  8. B

    Ford 3000 hydraulics

    Hey everyone I have a 67 ford 3000 and I ve seen come gunk in my hydraulic fluid and I m wondering if I can drop the fluid and flush the system with something I ve heard of guys filling the hydraulics back up with diesel fuel and let it run for awhile then drop the diesel and fill it back with...
  9. B

    Ford 3000 intermittent hydraulic

    I have a 67 ford 3000 and the hydraulics work intermittently both 3 point and remotes are doing it sometimes everything works just like normal then other times I have nothing the 3 point won t raise and my remote won t work I ve changed the fluid and have tried priming the pump but when I remove...
  10. B

    Carburetor ford 4500

    Hey everyone I m wondering will a carburetor off a ford 3400 industrial 3cyl fit on a ford 4500 industrial 3cyl? They look the same but the tags are gone off both so I m curious if they are the same? The mounting holes seem to be the same and Intake seems to be the same as well.
  11. B

    Ford 2000 rims

    Is the lug pattern on a ford 2000 the same as an 8n? I have a good set of 12.4x28 on an old parts 2000 and want to see if they will go on a 8n
  12. B

    Ford 800 hoods

    Hey guys are all the hoods for the 2000,3000,4000, 600 and 800 s pre 1965 the same? Is the hood from a 1963 4000 go on a 841?
  13. B

    ih b414 fuel pump

    I installed a new needle that goes between the fuel inlet and carburetor installed all new lines with the electric pump and blew out the fuel inlet on the carburetor still stalling out when I put a load on it
  14. B

    sos conversion

    I'm wondering on the pre 65 tractors with the sos what tractor transmissions can be swapped to a regular manual? and when you do the swap do you need to swap out the rear end as well since the pto engagment is Levar on the manual and cable on the sos
  15. B

    ih b414 fuel pump

    I m running a 2-4 psi pump so I would think I have enough pressure so could it be something else? Like I said tractor starts and runs great will idle fine and when i throttle all the way up it is also fine and it will run wide open for as long as I want but the moment I put it in gear and try to...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top