(800) 853-2651
SHOP NOW

Recent content by ed12345

Yesterday's Tractor Forums
  1. E

    Log splitter table

    Anyone build a log splitter log catcher table? Thinking of using 1” emt for the slats. Roughly 3 ft by 3 ft Looked at the Timberwolf and rugged made ones for ideas but will make it custom for the box wedge splitter I have Thoughts and suggestions
  2. E

    Log splitter with gx390 engine

    What is the quietest muffler you can put on a log splitter with a Honda gx390 motor. Purchased flanges to go to a 1 inch pipe with pipe thread so will use black iron fittings to get where I need to be. Was looking at a generator muffler Just want the quitest muffler available that doesn’t...
  3. E

    Old Electric Motor

    sounds like a wiring issue Years and years ago if you got a shock from a refrigerator you would just turn the plug over and stick it back in - shock eliminated Start with the easiest - no cost possibilities first use a volt meter and check: 1.) your wall plug just to make sure its wired...
  4. E

    Literature---1963 Oliver 1600 4 Wheel Brochure

    3-16 rollover plow is what I'd match up with this tractor (or 4-12 non-rollover) -- same for all the 50-60 drawbar hp tractors (Ford 5000, IH 666 & 686, JD 3020, etc). A non rollover pulls slightly easier but think it would struggle with 4-16 or 5-12. You can always find the guy who loads...
  5. E

    Kubota BX2200

    problem is there is a very high chance that the several hundred starter you just purchased (and can’t return) doesn’t fix the problem. Start with the $10 solution first had the same steering issue and while you could have an internal leak the pictures in the other post clearly show it’s the...
  6. E

    Kubota BX2200

    No no no Their are a number of safety switches that build up just enough corrosion preventing the starter solenoid from fully engaging. The starter circuit appears to work as it should but doesn’t have enough power So you would need to check/clean/replace every safety switch and connector for...
  7. E

    Kubota BX2200

    I responded to your other post and just saw this Start with the easiest and least expensive first with the highest probability it’s the problem Is put in the horn relay in the starter circuit. Wire that tells the starter to engage goes to the horn relay and horn relay tells the starter relay...
  8. E

    Bx starter

    Not sure what you mean by stuck Check the mounting plate to make sure it isn’t bent If not engaging or sometimes engaging add a horn relay in the starter circuit. The safety switches build up enough corrosion to drop the voltage/current just enough to make you think it’s ok but won’t let the...
  9. E

    Farmall super m with m and w stuff

    Only problem is the drive train / trans especially the rear end can’t handle that much HP. The IH 560 with a 6 cylinder ( next generation with M ) had some big rear end issues ending in an expensive recall. Good job getting 100 hp out of an M
  10. E

    Can Anyone Here Convert MiniDV Video Tapes to Digital File?

    Whoever you use have them give them to you in a MP4 format on a thumb drive. Stick the thumb drive into your computer and copy the file using windows explorer You can even do it your self it’s a little more complicated but works. Their are a lot of inexpensive products on eBay and amazon...
  11. E

    Hydraulic line replacement

    Rented one once and a rock fell and bent a hyd fitting. They were standard 1/4 inch pipe thread fittings and hyd hose. Nothing special You might run into an o ring or JIC (flared) so just be careful if the threads don’t match Surplus center is generally where I get my stuff from. And they...
  12. E

    Plastic mulch layer

    Good points Will be pulling it behind a 4 ft rototiller behind a 22 hp Kubota bx. I rip the ground with a subsoiler before I rototill. Will build hitch to connect with adjusters and some floating to level Did this before with angle iron. Eventually redesigned the plastic layer for a 3...
  13. E

    Plastic mulch layer

    Good points Will be pulling it behind a 4 ft rototiller behind a 22 hp Kubota bx. I rip the ground with a subsoiler before I rototill. Will build hitch to connect with adjusters and some floating to level Did this before with angle iron. Eventually redesigned the plastic layer for a 3...
  14. E

    Plastic mulch layer

    Wow! can't believe this site degraded into environmental activism
  15. E

    Plastic mulch layer

    Looking to mount this behind a rototiller
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top