(800) 853-2651
SHOP NOW

Recent content by fordfx413

Yesterday's Tractor Forums
  1. F

    806 low oil pressure

    Pete, I think I know the problem now, I found my orfice plug in a sack with the old cam bearings... Thanks for your help. I guess i get to take the front of the motor apart. Extremely upset with myself on this one....
  2. F

    806 low oil pressure

    I have a 806 with a 361 engine. I just rebuilt the engine, all bearing clearances plasti gaged all were in spec. I have 30wt in it, oil pressure at rated speed with oil warm is 30 psi, when i drop it to idle it drops to around zero. I always check all galley plugs, they were all in place. I...
  3. F

    1466 low lube pressure.

    I have a 1466 with 5-7 psi of Lube pressure at mid to high idle, around 1-2 psi at low idle. Once the oil warms up the tel lite will come on. New hy-tran and filter. If i hold the T/A lever in the middle position, lube will increase a couple PSI. I capped off clutch booster, seat valve and...
  4. F

    1466 hydraulic issue.

    I have a 1466 with a hydraulic problem. The remotes will not work with the 3 point all the way down. If you pick the 3 point up, lever 1 from the bottom of slot the remotes work just fine. Could this problem be in the unloader valve? Thank you
  5. F

    4430 quad range rebuild

    Thank-you. I did notice they are different thickness. I did buy new ones incase I overspread when I took apart. I will make some snap ring holders
  6. F

    4430 quad range rebuild

    Working on a 4430 quad range that lost A and D. Shift collar and gear broke. We have it disassembled and parts ordered. Do you need the dummy shaft, and snap ring tools to put back together?? or im sure they just make it easier and help not wreck the new snap rings. I would like to find the...
  7. F

    John Deere 4650 Head Gasket

    I have a 4650 in the shop that was pushing compression in the radiator. Head gasket and head bolts looked like they have been replaced before. The head gasket was not blown, however when i measured my liner protrusion, a couple sleeves were sitting around .00 maybe slightly below the block...
  8. F

    Deere or A&I clutch

    I always put Hy-capacity clutches in. Good quality, never had a problem.
  9. F

    3020 PS Problem

    Hy-gard
  10. F

    3020 PS Problem

    Thats what he said, I told him originally that is was probably a linkage problem in the shifter. But today i unhooked the directional rod at the shift handle, put it in the neutral position and put the lever in 1st forward, the tractor went forward at about half speed if everything was hooked up...
  11. F

    3020 PS Problem

    After going through the clutch drag tests.. When i was checking c3, b4, b3. With the direction selector in neutral position and speed selector in 1st, the tractor moves forward quickly!. I had the cover off the transmission to replace the cork gasket and all brake packs had clearance and discs...
  12. F

    3020 PS Problem

    I checked pressure on every clutch pack. all pressures look normal. all packs engage and disengage when supposed to according to the chart. Seems to get better as the transmission warms up.
  13. F

    3020 PS Problem

    Working on a 3020 power shift. Just finished installing new brakes due to the old brakes starting to come apart. Problem is and it did this before my brake repair.. When you put the tractor in reverse, the engine bogs down before the tractor starts to move. Forward works like normal. Also when...
  14. F

    IH 1486 Rear end?

    I went and looked at a 1486 with some transmission issues. The tractor would get stuck in high range and could not move the lever out. It also needs a clutch so maybe that will solve that issue. Do these tractors have differential issues? I jacked up the rear of the tractor and spun one wheel...
  15. F

    67 424 stalling please help

    Spray a little brake clean or ether around the throttle shaft. Possibly sucking air.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top