(800) 853-2651
SHOP NOW

Recent content by mikewood869

Yesterday's Tractor Forums
  1. mikewood869

    Ford 755 hoe swing post

    The swing chain ended up braking in three different spots. Does anyone know how to tell what the part number of the swing post would be? Apparently there’s 2 different numbers. Would that be for the hoe or something else? The hoe and loader were assembled in 1966 or 1967 755 swing post
  2. mikewood869

    Ford head remanufactured places

    Valves, springs keepers, seats, guides, and needs to be decked
  3. mikewood869

    Ford head remanufactured places

    Good morning I’ve been shopping around for a remanufactured head for a Ford 755a with 9/16 head bolts, I tried Alexander Tractor, but they did not have anything but I remember there were places in Ohio and Pennsylvania, but can’t think of the name that offer remanufactured heads. Mine needs...
  4. mikewood869

    Galfre gts 520 tedder gearbox oil

    Anyone know what the gearbox oil would be equivalent from type ep420? It looked like 80w90 or 80w140
  5. mikewood869

    3000 ford aftermarket gas fuel pump

    I’ve had good luck with this pump, I’ve had this one for about 10 years. Fuel pump
  6. mikewood869

    Ford 3000 gas starter

    Not cheap, but so far I’ve had good luck (knock on wood) with this starter, I’ve had it since 2019 and my 4500 gets started a lot Starter
  7. mikewood869

    Ford 7500 engine

    I ended up dropping the 755a head and rocker shaft off at the machine shop today and we’ll see how that goes. Hopefully the head comes back good. Would the rocker bolts be the same side or 1/2? I didn’t see a part number by the oil filter side of the block. I’m not sure if the number is on the...
  8. mikewood869

    Ford 7500 engine

    I end up picking up an engine from a Ford 7500 tlb, does anyone know if the head and rocker shaft will work on a 1987 Ford 755a motor? I forgot about the part number by the oil filter
  9. mikewood869

    Ford 775a back head

    Finally took the head off, the blew head gasket blew bare minimum. The last rocker bolt next to the cab was really tight (#3-1 were less but about the same). When the tractor was running, it had heavy blow by. Fast look the block holes looked clear, but I’ll take a better look in the morning...
  10. mikewood869

    Ford 775a back head

    Ended up taking the valve cover off on this 755a to do a head gasket, turns out half of the rockers are getting oil and the other half aren’t. I don’t know for how long this happened but half is definitely dry. Could this be from a clogged oil passage or could this be the oil pump? When I put...
  11. mikewood869

    24 volt on a 755a

    Anyone know if you could run 24 volt on a 755a system or would that burn the wiring harness out a long with the starter? I’ve always had slow cranking with this in the winter. I’ve had two good batteries on this. Just wondering if these could have been run in 24 volts anyway
  12. mikewood869

    Ford 5000

    I ended pulling the tac out, then pulled with key switch wires out and used a volt meter to see what’s what, then use the volt meter on the key switch position and see what tabs do what. Once the tractor run, snake them back under and attach to them to the key switch and then snake the key...
  13. mikewood869

    Pertroix Ignition life expectancy

    Just out of curiosity, how long does the electronic ignition last on a tractor before it dies? I put one on our 1950 8n almost 10 years ago and it finally died (tractor probably ran with it for 7 years). Haven’t killed a coil yet. Seems like the most issue before electronic ignition was killing...
  14. mikewood869

    Starter Engage Flywheel

    I ran into that problem on a Ford 531, I went from a gas engine to a diesel engine and kept the gas ring gear then tried to use the diesel starter. That didn’t work and I ended up splitting the tractor again and putting on a new diesel ring gear after the gas stater went out. I got 2 years...
  15. mikewood869

    New Holland 1411 hp

    Mower conditioner. 1411 is rubber rollers and 1412 is fails
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top