(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. C

    1105 clutch alignment tool

    Looking for a clutch alignment tool for a 1105. The clutch disks call out 27 spline but all I have found searching the internet so far are 25 spline. Does anyone have a part number to search or supplier to check?
  2. C

    3010 block

    What are the differences between engine block casting r26160r and casting r32020r. Both are 4 cylinder one is 3010 the other 3020 I belive. Can they be swapped? Lost an engine in my 3010 crack through the o ring lands for the liner.
  3. C

    3010 steering

    Working on another diesel 3010. Used it to drill in some seed and the steering was fine. Went to move it after setting for a few days and the steering is acting up. First it would turn right fine and turning left there was no power steering then it changed to left had steering right doesn't...
  4. C

    MW Turbo Boost Psi

    How much boost did the M&W kits put out for the new generation John Deeres?
  5. C

    1105 3 point lifts slow

    Finally getting some implements sized for the 1105. Picked up a 4 bottom rollover plow for it. This is the first time I have used the 3 point on the tractor. Problem is it lifts it extremely slow, probably close to 20 seconds to bring it up. When no load is on the 3 point it seems to move...
  6. C

    1105 vs 1085 lower lift arms

    Have an 1105 with the non sliding lower 3 point arms. Found a salvage 1085 that has the sliding arms. Will the 1085 arms fit on the 1105?
  7. C

    Hesston 6450 swather

    I have a hesston 6450 swather with a 6465 auger head. I am getting a loud growling sound while cutting with it. Intermittent can be in light hay or heavy may cut 2 passes no noise or every 40 feet growls away. If you pull it in reverse and take the load off it stops. I have a sprocket for...
  8. C

    1105 540 to 1000 pto

    My 1105 came with 540 pto. Will just installing the 1000 sub shaft change the speed, or did some not come equipped to run 1000? Thanks
  9. C

    Weevils

    How do you control weevils in ground corn storage? Currently stored in a feed room, they are everywhere. Thanks
  10. C

    1105 oil leak

    Do the bolts for the front engine support have access to oil? Have an oil leak coming from the support on the right side.
  11. C

    Case 2 way plow

    There's a case roll over plow in an online auction that I can't figure out. It appears to have what looks like a rotary cylinder on the front but also a regular cylinder behind it. Was the regular cylinder added because the rotary went bad? Or is what I think is a rotary cylinder something else...
  12. C

    1105 3 point

    How do you remove the u joint to take the 3 point lift links off the lift arm? They are froze and can't adjust the threaded part. Thanks
  13. C

    1972 John Deere 820 injection pump

    1972 John Deere 820, Is there a gasket to go between the injection pump and where it mounts to the engine? Can't find it on jdparts. Neighbor pulled off this pump so I don't know what was there. Thanks
  14. C

    1105 hyd pump drive coupler

    Got the hyd pump out today. The drive coupler is worn from the bolts and rubber bushing going bad and wallowed the holes. Just scrolling around can't find the coupler or bushings. Tried part number but it doesn't get any results. The number is for the entire assembly. Had any one else ran into...
  15. C

    1105 injection pump model

    Was cleaning up the injection pump area to check the timing on it and the ear with the timing mark is broken. Searching the model number against avaliable pumps I can't find a match. Appears the model is 3268F283. Is this a correct pump or do I just need to get a pump that is for the 1105-1100...
  16. C

    1105 injection pump

    Cleaned up the pump to see where it is leaking and it is the throttle shaft. How hard is it to reseal that? Guessing I can get a reseal kit as I see different ones for sale. If the timing of the pump is retarded would that cause excessive smoke at idle? Will clear up quite a bit when...
  17. C

    1105 massey problems

    Got the 1105 moved to my place. Here's the issues so far. Muffler needs replaced,easy enough. Pto isn't working, saw the lever on back is not hooked to anything hope that is all it is. 3 point only lowers about 4 inches knob behind the seat just spins. I think there is possibly another...
  18. C

    1105 massey

    Made a deal and got a 1105 yesterday. Guy that has it parked it when he got a skid as he could no longer get into the tractor. It was used at a feed store to load hay. I will need a couple batteries and see if it will start. Been sitting since 2016 or so. He said it does smoke when it is...
  19. C

    Deltared

    You don't have any 825 plows dead in your area? Got mine working plowed one field and it cracked the front cover on the vane cylinder. The welder at work isn't sure how good the repair can be since it cracked though a port and down to the center shaft. I am more optimistic but he is a worried...
  20. C

    John Deere 825 rollover plow vanes

    Think I found the reason the plow won't roll over. One vane has a crack running down edge. Vanes are hard to come by and around $400. Does any one know where I might find some good used ones part number a10881a? Thanks
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top