(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. R

    Ford Funk Starter

    I have a Ford Funk with a 6 cylinder "Industrial" flathead. When I tried to start it the starter ran but did not turn the motor. It had a funny grinding sound. No previous starter problems. Video attached with sound. Is this characteristic of anything?
  2. R

    Front Mount Distributors

    What is the experience with the inexpensive (about $35) front mount distributors sold on Amazon? Thanks! Rich
  3. R

    Spark Plug Wires

    I need to replace some spark plug wires. I have some pre-made wires. Is there a way/trick to thread them through the spark plug wire tube? Thanks! Rich
  4. R

    Jubilee Radiator

    I have gone through two radiators...one last summer and one this summer. They start leaking at the upper seams. I believe they were one of the standard Chinese replacements. The question... can anyone suggest a good radiator for a Jubilee? Thanks! Rich
  5. R

    800 PTO Shaft

    I have an 800 series tractor I use to mow using a bush hog. The lever to engage the PTO occasionally pops out of gear. I notice the PTO shaft has about 1/2" forward and backwards play. I am guessing this may be the problem. I assume I need to remove the PTO shaft and see what is going on. Any...
  6. R

    8n No Spark

    I have an 8n that has been converted to 12V. I put a new distributer and 12V coil on it but no spark. 11.6V at the coil. The starter seems to drag badly and gets hot quickly. Could that draw enough current to be the problem? Thanks! Rich
  7. R

    JD 915 Header

    I am changing the knives and guards on a JD 915 header. This is the first time I have done this...so don't know what I am doing. After putting some new knives and guards on I found the hold downs were tight against the knives, not allowing the bar to move. (I did not replace the hold downs or...
  8. R

    Jubilee Lift Arms

    I have a Ford Jubilee used to pull a 5' bush hog. On occasion the bush hog will raise up without me touching the lever, then will not go back down. The hydraulic fluid was ugly...contaminated with water. I have changed the fluid twice. The second change looked pretty good but still some...
  9. R

    JD 6620 part-seal

    This is a picture with the "Fingers" removed from the back of the chaffer frame. The rubber seal above this is pointed out and you can see it is torn and a piece is missing. In a previous thread 620 John said this was in the "shoe auger pan parts diagram" ...but I can't find it. Can anyone point...
  10. R

    JD 6620- fingers

    I have a JD 6620.There is a piece missing from what the parts diagram calls a Cover. When I removed it to repair it I noticed there was a part in the parts diagram called the Fingers which appears to be absent. I am assuming the piece broke off because it was not supported by the Fingers. Parts...
  11. R

    JD 6620 Chaffer and Sieve

    I have had this 6620 for about a year, am new to combines so still on a steep learning curve. There are sections missing from both the chaffer and the sieve. Are these replaceable/fixable? Thanks!
  12. R

    Hydraulic Hose

    This is a hydraulic hose from Ford front end loader circa 1960. Does anybody recognize these? Are they still available?
  13. R

    Hydaulic Hose

    This is a picture of a hydraulic hose from a Ford front end loader circa 1960. Does anyone recognize this...are they still availaqble?
  14. R

    JD6620

    I have a JD 6620 that I am harvesting Rye with for the first time. I am getting a lot of seed heads (without seeds) in the grain. The manual says to run the cleaning fan at 800=900 RPM for rye. If I increase the fan RPM over 300 I start to loose seed, and at 400 RPM essentially no seed comes out...
  15. R

    JD 6620 Combine

    I am trying to drain and refill the final drives on a JD 6620 combine. The manual says there is a fill, check and drain plug. I can easily find the fill and check pipe plugs, but do not see a drain plug anywhere. Anyone familiar with these? Did they all have a drain plug? Thanks!
  16. R

    JD 4430

    I have a 4430, that lately when I try to start it the engine makes a load Ka Chunk - Ka chunk - ka chunk noise as it turns over. After 2-3 times of this it starts normally. Any ideas? Thanks, Rich
  17. R

    JD 670 Compact

    A friend has a JD 670 compact tractor with a 3 cylinder Yanmar diesel engine. It has been lightly used; only about 400 Hours on the engine. It sat for close to a year, then when tried would not start. I have drained the fuel tank and put in fresh diesel. The manual says the engine is Self...
  18. R

    JD 6620 Transmission-Again:)

    I recently changed the transmission fluid on this combine. The specs say it holds 11 quarts. When I drained the fluid there was less than a quart. Knowing the machine had not been maintained I was not concerned. I put in 11 quarts of 80-90 gear oil. I drove it around the edge of a field and...
  19. R

    JD 6620 Trans. Screen

    I have a question about installing the transmission screen. I installed it with the open end with the collar towards the drain plug. I pushed the screen in, then put in the plug. I wondered why there was a rubber wedge/gasket just inside the opening of the screen. It did not seem the screen...
  20. R

    JD 6620 Transmission

    I am trying to change the transmission fluid on a JD 6620 hydrostatic drive combine. The manual has a picture, and describes loosening a line that goes into the drain plug (blue arrow), pushing the line up and then pulling out the drain plug (red arrow) and screen. I have pulled the line out of...
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top