(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. C

    generator problems

    I have a 52 VAI that the generator went bad. I have a spare generator but the one on the tractor has 2 wires to it and the spare one only has 1 wire. HOw do I connect it. it is a 6 volt positive ground system. thanks
  2. C

    tallman products

    Are Tallman paint products good? I am looking at painting a tractor and see ads for Tallman products/ thank you for your replys
  3. C

    rough finish

    I have painted a tractor using rattle cans. I am satisfied with how the tractor looks but the finish is rough. I have checked out others and their finish is a lot smoother to the touch. Any idea what I did wrong or didn't do that I should have
  4. C

    rough finish

    I have painted a tractor using rattle cans. I am satisfied with how the tractor looks but the finish is rough. I have checked out others and their finish is a lot smoother to the touch. Any idea what I did wrong or didn't do that I should have
  5. C

    paint sprayers

    In there past there was some discussion on paint spraying systems for people without large compressors. What were the systems called and any recommendations? thanks Bill
  6. C

    vac clutch housing

    Does the clutch housing on a VAC need to be drained as it is on the SC? If it does where is the drain? thanks for the answers
  7. C

    determining year with id tag missing

    Is it possible to determine the year of a tractor if the serial tag is missing? Is the serial number stamped anyplace else? thank you Bill
  8. C

    38 RC cooling system

    I feel kind of dumb asking this question but, does the RC tractor have a water pump and if it is where is it? Looking at the tractor I see no signs of one and in the repair manual that I have they list water pumps for the older case tractors but skip over the RC. My RC seems to be running hot...
  9. C

    need help with VAC running hot

    I have a VAC that after about 10 to 15 minutes of use the temperature gauge reads close to 200 and continues to climb. There is plenty of coolant, there is not thermostat on the tractor and the fan runs fine. When I shut it down the water in the radiator is real hot. What should I check as...
  10. C

    electric start on rc

    I have a Case RC with hand crank. Heard a rumor that the starter on a SC would fit on an RC. I am posing the question if the starter from a SC would fit on the RC and then would the ring gear from the SC also fit on the RC. The tractor runs fine if it is pulled to start but not starting off...
  11. C

    information question on exhaust manifold

    As I mentioned in an earlier posting I am working on a 56 VAI I recently picked up. Today I pulled off the exhaust manifold and discovered there must be a half of dozen or better cracks in the exhaust manifold, some going about half way around the manifold. In addition there are 2 holes in the...
  12. C

    head gasket on 1956 vai

    I picked up a 56 VAI, that was smoking a far amount and was lacking on power. I pulled the head and the head gasket between 2 and 3 cylinders was burned away and the valves on number 3 cylinder are badly carboned. What would cause the gasket to burn away that way and what should I be checking...
  13. C

    6v to 12 volt conversion

    I wrote awhile back about the VAI I just bought in which they tried a conversion to 12 volt. What they did was run the positive connection off the battery to the starter switch and from there they went to the starter and the coil directly and from the coil to the distributer, and negative from...
  14. C

    6volt to 12 volt conversion

    I just purchased a VAI with a case belly mower. I noticed that it has a 12 volt battery and 12 volt coil but they disconnected the wires from the generator. It starts and runs fine but I have to charge the battery. Does it hurt to run it this way? To complete the conversion to 12 volt is all...
  15. C

    vai exhaust manifold

    I just purchased a Case VAI and noticed that on the exhaust manifold there are two holes. They appear to be drilled holes about 3/8" in diameter, what are these for and should they be there or should they be plugged? thank you for your advice Bill
  16. C

    6 volt starting system

    I have a VAI and a SC that both use a six volt battery system. Trouble is on both of them I can not get a battery to last over a year. I put a new battery in and all works good, but in a short time it hardly has the power to turn over the engine. It does not matter when I recharge the...
  17. C

    head bolt torque on RC

    What should the torque be on the head bolts for a RC? They are 7/16 fine thread. The one book I have says 70 ft-lbs but that seems too much to me/ thanks
  18. C

    case rc light gray paint

    What is the spec for the light gray paint on a Case RC? Does anyone know of a part number of the paint or where to buy it? thanks
  19. C

    38 RC

    I am working on a 38 RC. I picked up an operators manual on RCs and the following from the manual has me confused. "The magneto on this engine is equipped with a manually engaged impulse coupling. It must be tripped by hand to engage coupling for starting. Move trigger toward engine." I...
  20. C

    case sc motor lift

    I am looking for ideas as to how to connect a scraper blade to the motor lift on an SC. The connections for the cultivator are too narrow for a standard 3 point hitch blade. Has anyone done this or am I looking for something that does not exist. thanks for any ideas
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top