(800) 853-2651
SHOP NOW

Recent content by Ed Douglas

Yesterday's Tractor Forums
  1. E

    3010 remotes

    I’m afraid my experience with John Deere remotes was the culprit….. this dumb old guy had the levers the wrong way…lol!
  2. E

    3010 remotes

    Bingo Jim
  3. E

    3010 remotes

    Thanks y’all
  4. E

    3010 remotes

    Yes… the hoses were properly installed with the levers appropriately oriented… I had done that a few times taking haybine off and putting the balor on
  5. E

    3010 remotes

    Evening Chums Got a new to me 1962 3010 John Deere tractor to wrap up my hanging season last year…. It was absolutely flawless…. I have only used various Ford tractors over the years and was very satisfied with the 3010…After wrapping up with the hay last year, I uncoupled everything and haven’t...
  6. E

    Identification help?

    Thanks my friend!
  7. E

    Identification help?

    Good evening forum chums, Recently got a John Deere 3010 …1962 variety…. I was cleaning out the toolbox and organizing some things and I found some kind of cover and I can’t figure out where it was and where it should be…. It’s painted on one side and not the other so I figure maybe one of you...
  8. E

    Front end swap

    Good Morning Forum Chums! I’m still getting to know my new to me John Deere 3010 narrow front Tractor…. It’s a 1962 and I found a wide front end off of 4010…. I’m not sure of the year. I wondered if I could swap out the narrow for the wide…. The 4010 front end was obviously repaired at one...
  9. E

    Spark plug recommendation

    Good Morning Forum, I recently picked up a 1962 John Deere 3010 gas model with electronic ignition…. Looking for some input as to what plug I should use… It’s got Pertronix ignition, coil wires, and a flamethrower coil….. Lastly, should I use the recommended John Deere spark plug gap?…. I’ve...
  10. E

    EI question

    Good Evening Forum I have what I hope it’s not an absolutely stupid question….. just purchased a John Deere 3010 with electronic ignition…. I have absolutely no experience with EI….old Ford guy….6 volt, points …plugs…condenser…..cave man stuff! The tractor is 12 V positive ground….. For future...
  11. E

    3010 Starting issue

    Tx Jim and rrlund…. It was in fact, the neutral safety switch ….many many thanks! I had just purchased the tractor. It’s got 3600 original hours on it and the shop manual is on its way….. being an old Ford guy…. I had not even thought there was a neutral safety switch in that position…. Lord...
  12. E

    3010 Starting issue

    Morning Forum…. I had an issue with my 3010 starting sometimes I would have to turn the ignition switch off and onto two or three times before it would engage…. The dash lights would come on and dim while the ignition switch was turned to the start position… finally the other day it stopped...
  13. E

    Howard Rotovator

    Hey Chums, I recently purchased a 1939 tractor with a Howard trans and Tiller…. I would be most grateful if anyone had any idea where I could get a hold of any literature….manuals, set up instructions, maintenance, etc. Many thanks in advance! Cheers!
  14. E

    Cut out and polarization

    Hey Forum Chums To set this up....non running 2n......new battery....new wiring harness.....all grounds and connections sparkling....cut off relay removed and all connection points wire wheeled to a mirror shine......when I go to polarize the Generator at the cut out.....I barely get a...
  15. E

    GP-6050 Tractor update

    Thanks Tim...no other code other than GP-6050 stamped in the top of the head...regarding the manifold...I like it...and the design...wish I had a few more!!
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top