-
M
ford 8n throtle response
I didn't realize you would think a thing like that would cause me stress. In fact working on that old tractor is a stress reliever. So again, is there an adjustment that can be made to the linkage to eliminate that delay or is that common on those tractors. Thanks, Jim -
M
ford 8n throtle response
when the throttle lever is at it's lowest point and I begin to increase the engine speed, the speed doesn't increase until the lever reaches the 5th notch on the throttle plate. Is something out of adjustment? How would I correct that? Thanks, Jim -
M
8N replaceing points etc
Is there a special procedure for replacing the points, condenser and rotor on an 8n side mount distributor? Thanks, Jim -
M
8n coil resister
How about the resister, if that wasn't working properly could that somehow contribute to a miss in the engine? -
M
8n coil resister
do coils get weak or do they work or not work? and if the resister is not working properly could that cause a miss in the engine? thanks, Jim -
M
8n coil resister
what is the purpose of a resister on the coil, Thanks, Jim -
M
additives in ford 8n gas
thank you for your info. as always you all have been very helpful. Jim -
M
stearing box lube 8N
How do I check or add lube to the stearing gear box on an 8n Thanks, Jim -
M
additives in ford 8n gas
Givin todays gasoline, is it necessary to use any type of additive in an 8n ? Jim -
M
spark plug clearance 8n
all fixed, tank was installed incorrectly. this is my first experience with an 8n ford "with any tractor for that matter" and I appreciate the information you all have offered. Now to tackle the miss under load. Jim -
M
spark plug clearance 8n
my gas tank is much lower than that, its right on top of the plugs -
M
spark plug clearance 8n
the incorrect reinstallation theory might be right. should the tank fit up under the rails on the hood when the hood is laying upside-down on the ground or just fit right on top of the rails? -
M
spark plug clearance 8n
the plugs that are in the tractor are autolite 417 no anti fouling tips. I changed the tank to one I bought from yesterday's tractor for just that reason, no plug clearance, but their still isn't any clearance. Jim -
M
spark plug clearance 8n
Hello, How much clearance is there supposed to be between #1 spark plug and the bottom of the gas tank on a ford 8n tractor? On mine it's tight to the tank. Is that normal? Thanks, Jim -
M
8n misfires under load
I will take all suggestions into consideration including backing UP the hill and get back to you all at a later date. Thanks to all, Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy