(800) 853-2651
SHOP NOW

Recent content by Monkeymaster

Yesterday's Tractor Forums
  1. M

    Electrical Coatings - Snake oil

    Hello What do you all use to coat your battery terminals, the wire eyelet to the frame/block and other electrical connections, to prevent corrosion and or bad connections. Seems like the battery connections today, do not stay "connected" like years past, maybe a cheaper type of lead on the...
  2. M

    60 3 pt aftermarket

    Hello I have an aftermarket 3 point that I was told came off a 620 The axle mounts are 1 1/2” too high The angles bolt onto the drawbar mount just fine. Is the draw bar frame that mounts to the main casting supposed to have 1 1/2” spaces, which would drop the angle brackets 1 1/2” thus...
  3. M

    60 vapor ?

    Video and 2nd pic are too large to publish according too YT ?🤦‍♂️
  4. M

    60 vapor ?

    Hello My 60 has some vapor coming out of the speedometer/tac cable attachment point to the power trowl. Is this just normal windage/pressure that is escaping because I do not have the cable attached, or is this an issue I should look into further ? There is no oil or moisture evidence running...
  5. M

    2 banger hydraulics

    Thanks everyone This will help tremendously Much appreciated
  6. M

    2 banger hydraulics

    Hello JD 60 Looking for some pictures and advice on how to pipe/plumb the hydraulics for using the 3 point, and or the remote cylinder coupler, without switching the pins/rods/hydraulic caps every time I need to switch from 3 point to cylinder. I have read some other forums this is possible to...
  7. M

    Hydrulic hose leaks

    Hello I have a 90 degree hydrulic hose fitting that is seeping/leaking where it swivels around. I assume there is no other fix, other than having new ends pressed on ? Thanks
  8. M

    2840 pto oil leak

    Hello, JD 2840 I had to run the snow blower this weekend, I noticed I had hydrulic oil seeping out around PTO shaft. Enough that I want it to stop. I assume I will need to replace BOTH #13 O-ring AND # 20 SEAL, to stop the seepage? Then, is #20 seal pressed into #18 casting/Quill? Then, I...
  9. M

    What is it

    JD parts We had several JD items here in the last 30 years 2020 2840 Lawnmowers one being LT180 I think 6 wheel Gators Anybody have an idea ? Thanks
  10. M

    POW steer fluid vs hy gard

    Hello This probably has been on here/discussed before, if so please share the link. Is the JD power steering fluid sold for the 2 bangers, the same as the newer Hy Gard hydraulic fluid ? I have both fluids, both look the same, currently only use power steering fluid only as power steering fluid...
  11. M

    60 power steering

    Thanks to all replys. Feel free to add , the more information the better.
  12. M

    60 power steering

    Thank you for the information and tips. I appreciate it.
  13. M

    60 power steering

    58 Report to Moderator PostPosted: Thu Jul 13, 2023 4:57 am Post subject: JD 60 power steering leak Reply to specific post Reply with quote Hello all The front lower seal of my power steering is leaking to the point it HAS to be fixed. So 1. Can this be replaced without pulling the...
  14. M

    JD 60 power steering leak

    Hello all The front lower seal of my power steering is leaking to the point it HAS to be fixed. So 1. Can this be replaced without pulling the pedestal? I assume NO. 2. Is there a COMPLETE gasket seal kit for this project ? 3. Any traps or tricky spots I need to be aware of 4. Has there...
  15. M

    Spring rock clean

    Hello Anyone have a good, mechanical attachment for removing rocks from your grass this spring, other than a power broom/brush? Pictures ? Thanks
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top