(800) 853-2651
SHOP NOW

Recent content by scrappy 35

Yesterday's Tractor Forums
  1. S

    timed her and now she pures

    i loosened nut and pushed it up bout half way between center and the end of hole just make sure it shuts off even and restarts even so you know you didnt go too far
  2. S

    timed her and now she pures

    I have a 2n and did a bunch of new upgrades to it but it always never ran right and ive been threw everything on at a last desperation i advanced the timing and now it runs like new funny how that something so simple was my problem go figure
  3. S

    Please Help Engine Noiseq

    could you let us know if it was a loose plug because I think hes rite it sounds like a loose plug or some type of air escaping someware that is deffinitly wierd sound just curious what it is
  4. S

    too much resistance?

    if you add more resistors than needed will that cause a coil too break up under a load and if you dont have enuff resistance can that cause the same thing or would that just fry the coil?
  5. S

    2n running rich

    also theres still quite a bit of water in the oil from the bad head gasket ive got to change it again would that possibly be a factor with the smoking?
  6. S

    2n running rich

    I just put a bunch of work into my 2n i converted it to 12 volt installed electronic ignition new radiator, plugs ,wires rebuilt carb all new metal lines and installed an exhaust stack and head gasket all compression is good and for some reason it idles great but i run it wide open it puffs blue...
  7. S

    exhaust out of the radiator hose

    thank you that was exactly wat i was looking for
  8. S

    exhaust out of the radiator hose

    I recently installed my 12 volt conversion and electronic ignition on my 2n and with the radiator out cause i need a new one i fired up the tractor to test the electrical it was blowing exhaust out of the upper radiator hose when i bought yhe tractor the radiator had been leaking and i thnk the...
  9. S

    head gasket

    could someone tell me wich is beter metal head gasket or soft material gasket thank you
  10. S

    stupid question

    number 1 cylinder is first one on front of block next to fan rite?
  11. S

    hood question

    im gona figure a way to do it and when i do ill post a picture of if
  12. S

    hood question

    i took the hood off to install my 12 volt convervsion and wanted to fix alot of cobbed up stuff from previous owners tractor has a loader which is also in the way
  13. S

    hood question

    i took the hood off my 2n and wasnt fun to do alone is there any way to modify it to just pivot up on the front bolts or is the gas tank always gona make it tuff it deffinitly lot nicer working on it with hood out of the way. just figure id ask
  14. S

    distributor question

    I think i figured it out I only bought the electronic plate im thinking i have to buy the complete kit and i have to use a round coil now i obviously need to do more research
  15. S

    distributor question

    i am installing electronic ignition in my distrbutor and have 2 questions there is a red wire coming off the ignition plate and im not sure what that hooks to of course no directions come with the kit it is a 12 volt system im assuming it goes to either the power or the coil not sure and my...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top