(800) 853-2651
SHOP NOW

Recent content by TEXAS TIM

Yesterday's Tractor Forums
  1. T

    MF 240 LIft arms won't lower.

    sir check that the arms are not binding where they attach to the lift top . you will see a bolt and plate hold the arms on i have seen them get binding with rust dirt and so on . also if the arms are free then you need to check if the shaft is free in the bushings of the lift top . i do not...
  2. T

    135-lift dropped dirt pan

    be sure to check the pressure regulator if it blew out no pressure . this a common problem be sure it works correctly while your in the side plate remove it and have it tested
  3. T

    Transmission oil in my bell housing

    sir the oil is leaking out around the two shafts thatb engage the clutch . remove tha large round housing that the throwout bearing is on . 4 bolt are it . you will have to remove the bearing lever before the shaft . the lever is attached to the clutch pedal . once you remove that tube the...
  4. T

    MF 165 power steering reservoir

    Sir their is no air in the system and has no vent. oil is on both sides of the piston in steering cylinder . Tim
  5. T

    1105 DIESEL QUITS , AIR IN INJECTION PUMP

    check the engine oil for diesel i have seen the front seal leak severly on the injection pump when running .
  6. T

    engine seized suddenly on starting

    before you split or take oil pan off put the tractor in neutral and see if it will freely roll. forgive me i have never seen your tractor model so i may give advise that wont work for you . hold the clutch in see if trans is free . if you find that the trans is free , tractor will roll then the...
  7. T

    MF 65 brakes

    I am with ERIC i have never replaced that rod without pulling the axle . it is a simple fix with the axle off .
  8. T

    gov.

    that makes sense i am glad you figured it out TIM
  9. T

    Injector Question on MF 40 Industrial

    sir its a banjo bolt reciever which would screw the return fuel lines to each injector , and return fuel to the tank . one injector will have a fuel line going to the tank the other two will have a banjo bolt sealing the metal return line to them . hope this helps .
  10. T

    MF 135 Timing

    hey take a air blower and blow air into the carb while cranking .it should start and if it does you have a low vac problem .good luck
  11. T

    govinor

    sir the governor only controls the high rpm's and has little influence on idle . if you have adjusted it it is not the problem . i would start at the carb and your idle air screws . the engine should idle and the governer only restricts rpm so as not to over rev the engine . please give me the...
  12. T

    Identify and problems MF35

    your going to have to take the oil pan off and start checking the bearings your crank shaft can be turned and correct bearings inserted . a new oil pump etc. my point sir is start looking at what is causing the metal in your oil . ps. do not start the tractor until it is fixed .good luck
  13. T

    mf 590 3 point wont drop

    hello sir on the end of the arms is a bolt . use a wrench and loosen the bolt your arms may have seized . i should clarify the bolt attaches the arms to the lift top . i am assumning when you shift oil to the loader the arms stay up.try that and if they still will not come down get back to us .
  14. T

    MF 1445 frame problems

    replace or repair the fraim member thats broken. is the trans broken or just bolts broke causing the fraim to crack ? take the tractor to your dealer to have it looked at for estimate , and correct loader part replacement .good luck sir
  15. T

    MF 30E

    thats been my experience too it is usally the lift pump.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top