Search results

  1. T

    Ford 4000 4 cylinder SOS leaking fluid

    Good evening all. I have a 1963 ford industrial SOS that is leaking oil out the cotter pin hole behind the engine plate. What is the likely source and repair options? Already had to split at the differential. Thought the oil pressure switch was broke off. Couldn't get it out with an easy out...
  2. T

    Ford 861 12 Volt Generator charging problem

    861 with 12 Volt generator - dash light is always on. Installed different rebuilt 12 Volt generator but the dash light still comes on. Resident expert neighbor says it is the voltage regulator. Where can a voltage regulator for a 12 volt generator be found? Thanks in advance for the help.
  3. T

    Sherman transmission oil

    What kind of oil should be used in a Sherman transmission?
  4. T

    Oil dipstick tube for Jubilee

    Anyone know where I can purchase an oil dipstick tube for a 134 engine? Thanks.
  5. T

    9N/2N steering column extension

    I have 9N/2N steering column extension. I believe Sherman made this. Does anyone know anything about them and if they are worth anything? Thanks!
  6. T

    MM 335 rear axle seals

    Does anyone know where I can get a pair of rear axle seals for a 335? What are the CR or National equivalent numbers? Thanks.
  7. T

    Ford 861 - 3 pt. lift not working.

    Ford 861. Lift worked fine with remote valve. Removed remote valve and replaced with block off plate. Now it doesn"t lift. Removed plug in pump and no oil is coming out when running. Proofmeter is working fine and pump "sounds" normal. Blew air through large (return?) line and could hear...
  8. T

    861 leaking transmission fluid

    861 leaking transmission fluid out of the inspecion hole underneath the transmission. What is the cause and what is the potential for rehabilitation? Thanks guys.
  9. T

    861 motor 'stuck'

    861 motor only turns about 2/3 to 3/4 the way around. Anyone have a good diagnosis? Had one do this before and a mouse had filled the 4th cylinder full of corn (in one night). Guess I will have to pull the head off this one.
  10. T

    4000 12V or 6V?

    Did the Ford 4000 come out in 1962 with a 12V to 6V Generator?
  11. T

    Ford 4000 SOS leaking

    Awhile back I posted a question about my Ford 4000 leaking fluid from the transmission into the hydraulic system. I put in a new oil pressure sensor and that didn't work although the light is coming on. I split the tractor Saturday morning, removed the seals and got the numbers out of the parts...
  12. T

    Ford 881 Diesel smoking

    Ford 881 Diesel smoking bad. Gray/blue smoke. Rings? Hasn't run in who knows how many years. Took an injector pump off another tractor and it won't get to full throttle. Also, when I put it in Reverse 1 the tractor dies. Any other gear it does nothing.
  13. T

    Tractor rim identification

    Anyone know what tractor this rim came off of? The tire is 11.2 X 28. Thanks.
  14. T

    Ford 871 Diesel injector pump

    I am getting fuel to the pump and fuel coming out of the bypass but not to the injectors. Any thoughts?
  15. T

    8N lift won't drop

    8N lift arms come up relatively good but then they won"t go down quickly when the lever is dropped. It will bleed down over a week or so. New oil. Please help.
  16. T

    Ford Wheel Centers

    I have two wheel centers allegedly from a Ford Tractor. They fit a 28 inch rim (6 bolt) but the axle hole in the center is bigger than that for the 600, 800, 601, 801, early 2000 and 4000. Any idea what tractor these are for and what they are worth. I would like to sell them. Thanks.
  17. T

    Ford 8N loader

    Loader on 8N with Vickers front pump - won't lift. Getting oil to both cylinders. Acts like it wants to lift but just can't get going. Replaced seal and bearing in pump. Loader worked a few years ago before I removed it to paint the tractor. Any ideas? Thanks! Todd
  18. T

    Ford 4000 oil leaking from SOS trans to hydraulic sys.

    1964 4 cyl Ford 4000 SOS leaking trans fluid from the trans into the hydr reservoir - it comes out of the dip stick tube. Advice and part numbers (carrier seals?) would be greatly appreciated. 540 PTO only.
  19. T

    Ford 5 speed Live PTO transmission

    Would a Ford 5 speed Live PTO transmission from an 800 or 801 work in a 3000 or 3400?
  20. T

    Ford spin out rims

    I have several sets of Ford spin out or power adjust rims and was wondering what their value is. No rust through - only minimal surface rust. None of them have had calcium in the tires it appears. Thanks.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top