(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. G

    deere 5425 recharge air cond

    how do you recharge air conditioner on deere 5425? where is the low pressure port located? what recharge equipment is needed?
  2. G

    Deere 870 dies when you put it in gear?

    Starts and runs fine but dies when u try to put it any gear???
  3. G

    Hyd filter light flashing

    Case 580 super E has the hyd filter light flashing. Is this something normally resolved by new filter and hyd oil change or a sign of other issues. This backhoe just gets occasional farm use.
  4. G

    New Slip Clutch For Deere MX 10 Mower

    Just got a new slip clutch for my MX10 mower. It is Deere part number AW35069 (Bondioli Pavesi). Just wondering if it is ready to go out of the box or if addition al slip test is required. Found a youtube video on a clutch that looks just like mine and would appreciate any comments as to...
  5. G

    Deere MX10 Mower Slip Clutch Help

    I have an 18 year old Deere pull type MX10 mower that I am trying to check the slip clutch to see if it operates properly. The adjusting allen screws are flush with the front of the clutch. The manual says the screws should be screwed all the way IN for winter storage (which I have never done)...
  6. G

    MX10 mower slip clutch help

    I have an 18 year old Deere pull type MX10 mower that I am trying to check the slip clutch to see if it operates properly. The adjusting allen screws are flush with the front of the clutch. The manual says the screws should be screwed all the way IN for winter storage (which I have never...
  7. G

    Help on replacing tilt steering cylinder

    Trying to replace the tilt steering cylinder on a Deere 5425 tractor. Got the hardened pin out of the lower end of the cylinder bracket ok but the Allen screws (6mm) on the bracket on the upper end of the cylinder are really TIGHT! We were using a 3/8 inch drive ratchet and aborted because...
  8. G

    4010 three point hydraulics real slow

    Moved a hundred or so round bales over 3 days with a 3 point hitch bale fork. Forth day no hydraulics not even power steering. Checked and added a little over a gallon of fluid. Power steering & brakes came back after a bit of jerking but hitch did not appear to raise at all. Tried it again...
  9. G

    460 engine oil

    Been using straight 30 wt engine oil in my farmall 460 (gas) forever. Would it be advisable to start using multi-vis 15w-40 in it? The 15w-40 is what I use in my Deere diesels. I am in southern Illinois.
  10. G

    Advice on 5085E tractor with loader purchase

    Trying to get some comfort in my old age. I am considering a Deere 5085E MFWD with cab, air and loader. I generally have my hay custom baled (200 4x5 bales a year) but will be retrieving them from the field and feeding the hay during the winter. Will be using a Deere MX10 pull type rotary...
  11. G

    4010 12 volt single battery

    Converted my 4010 to 12 volt a few years ago but kept my two 3ee batteries wired parallel. Would like to go to a single heavy duty battery. Anyone have any suggestions on where/how to place it somewhere to put it that is not under the foot platform? Thanks!
  12. G

    4020 pto clutch replacement

    How much should I budget for pto clutch replacement on my 1968 4020 synchro?
  13. G

    4010 power steering doesn't work

    My son was mowing with my 4010 and bush hog and was quitting for day and drove to the barn to blow off the trash. When finished the power steering would only move the front wheels a little each way. He checked the hydraulic fluid and it was low. Filled it up and there was no difference in the...
  14. G

    clutch source

    Anybody have a good source for replacement tractor clutches. Looking for a non-button, non-high capacity type for a 460 gas Farmall.
  15. G

    Farmall 460 TA repairs

    I have a Farmall 460 which is used to move about 300 round bales every year. The TA has gradually stopped working and it makes a little noise. I replaced the regular clutch several years ago it is seems to be just fine. My question is can the TA be repaired for a reasonable cost or should I be...
  16. G

    4020 fuel pump replacement

    Can you guys give me the correct steps on replacing the fuel pump on a 1968 4020 diesel especially on bleeding the air out of the system. Thanks!
  17. G

    Hydraulic/transmission oil for JD 870 utility tractor

    Going to change the hyd/trans oil in my Deere 870 tractor. Local Deere parts guy says according to their guide book I can use either the regular Hy-Gard or the Low Viscosity Hy-Gard. Which do you guys recommend? (Generally have some regular Hy-Gard around for my 4010). Thanks!
  18. G

    Tow Straps

    Are those tow straps safe to pull logs with using a tractor? Local farm store has the 4 inch x 30 foot 6,666 lbs working load limit / 20,000 lbs breaking strength. Seems to me I heard a local story some time back about a young person being killed when one broke. I just wondered if they would be...
  19. G

    More questions on installing mats in stock trailer

    Getting ready to install the 3/4 inch 4x6 mats in my stock trailer. One side of the mats has a groove cut in them about every inch or so running the 6 foot direction. The grooves are about a quarter inch wide and about 3/16 inch deep. The other side has a little raised oval shaped dimples on...
  20. G

    Horse stall mats for stock trailer floor?

    Can anyone tell me if the 3/4 inch horse stall mats like the farm stores sell will make a good floor covering for a 16 foot stock trailer floor (for hauling feeder calves) or will they be too slippery? My floor is rough sawn white oak (good floor but gets slick). If the mats are recommended...
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top