(800) 853-2651
SHOP NOW

Search results

Yesterday's Tractor Forums
  1. A

    Rear bucket width

    Hi I have a mf35 and I found a used 80 inch rear bucket. Is that too wide for it. Should I look for something much narrower?
  2. A

    Engine plug repair

    Hi My ih624 has been sitting for a couple of years. Started it and it ran for a few seconds. White smoke. Cant start it again. Found out it had no coolant. I remember i drained it. Put new water in and it is leaking heavely from radiator bottom and from an engine plug behjnd the water pump. The...
  3. A

    Pto shifter positions

    On my ih624 the pto shifter has three positions: pto independant, neutral and pto shifter lever, neutral. The two latter seems to do the same. The pto shaft ka. Be turned freely by hand
  4. A

    Run without exhaust?

    I Hit something lower than the mufler on my super major and it broke where it is mounted to the manifold. Will the engine run fine without the mufler?
  5. A

    Whining gears?

    Hi! Was out driving my super major for the first time doing some work in the field. When in 4/2 there is a whining noise. A little less in 3/1 and none in 6/5 and rear. Cant quite tell where it is comming from but the foot rest on the left is vibrating. Feels like touching an oscilating...
  6. A

    Fuel tap turns

    Hi! How many turns should the fuel tap be turned to be fully opened? I have seen some turn a few turns and some up to 20 turns. Is this supposed to be turned more than half a turn? Like a ball valve.
  7. A

    35 or 35x? Genuine?

    Hi. on my 35 the sticker says 35x. But that might not be from when the tractor was made. The front emblem is the massey ferguson. But inside the tachometer it says FE35 and also on the brass plate under the dashboard. According to this page...
  8. A

    Transmission oil for super

    There is around 8 liters of oil in the tranny of my super major. Don't know what it is but looks ok. I have a lot of 80w90. Gl4. Would it hurt anything topping it off with that? There are a couple of leaky seals, so am a bit worried that 15w40 will leak more. And I don't have 30 liters of...
  9. A

    Crack in manifold

    Hi. Today I noticed a crack in the manifold of my super major. Some soot has blown out around it. I don't have any experience in welding and also read it is difficult and risky to weld cast iron. A new manifold isn't cheap. Anything I can do to prevent the crack from spreading? A large...
  10. A

    Type of washer

    Hi On the fuel filter housing on my mf35 there are some type of steel washer caoted in red paper like material. The washer are found on the outlet and the two bleeding screws. What type of washer are They? One of them is missing and a copper one isnt the tightest. This post was...
  11. A

    Gasket for pto housing

    Hi Looks like the gasket (e1adkn7299) on my super major for the pto housing where the lever is attached isn't oil tight. A new one could be nice to try. Can't find a made one so want to make one myself. Want to order a sheet before taking it off. What is the original material? Is it cork...
  12. A

    Hydraulic inlet

    Hi. Looking for an inlet for hydraulic fluid on my super major. Might it be any of these two?
  13. A

    Return line for hydraulics

    Hi Want a return for the hydraulic oil. Both on my mf35 and fordson super major. Want to operate a to way cyl on a flail mower. So just need to set its position once in a while. It has two hoses, so need a place for the return hose. I can always switch the two when wanting to go in other...
  14. A

    Broken vent screw

    Hi I wanted to vent the fuel system on my mf35x. But the the vent screw on the purolator twisted off. Seems to be a bolt with a hole inside it. With a screwdriver I can turn the broken piece a bit but it stops at a certain point. Is it supposed not to be screwed all the way out? Is it...
  15. A

    Fix condensation

    Hi The tachometer on my mf35x has got some water on the inside of the glass. The tractor has been outside all this winter. Last winter it was in the barn and there was no water in it. But it has a cabinet, so it hasn't been raining on it. Is there a trick to remove the water or do I either...
  16. A

    Arrived

    Delete this Go here https://forums.yesterdaystractors.com/viewtopic.php?t=1606913 This post was edited by Axell on 03/11/2023 at 07:13 am.
  17. A

    Loosening hose clamp

    Hi there. The lower radiator tube is leaking from one of the ends. Looks like it has been there for many many years. I have soaked the clamp screw in wd40 but it will not budge no matter how much I try. Unfortunately it isn't hexagonal only slotted. So can't get a good ferm grip on it. I...
  18. A

    Flushing engine or not

    Hi I have an old 35x that I believe have been sitting for a long time by the former owner. The oil level was very low and very black. There might be a lot of sludge inside the pan and pipes. I have read about flushing engine with diesel. I am not too eager to remove the sump strainer...
  19. A

    New tachometer

    Hi! I want to put a tachometer on my ih624. I have been looking thru the parts list to find out where the angle drive is fitted but it does not show anything. So where is it mounted on the old McCormick tractors. The engine in mine is a D206.
  20. A

    Angle drive

    Hi! Is an angle drive for the tachometer repairable? Turning the brass cogwheel doesnt turn the output shaft to the cable. I can feel resistance and it also feels as if there is a similar cogwheel inside. It takes a bit of for to turn. Shouldnt it turn very easy? I dont see any way to...
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top